Question about Hyundai Audio Players & Recorders
I need to install the seat cover. Phillip, Replacement Seat Assembly Replacement 1.Remove the rear seat cushion assembly. 2.Remove the rear seat back assembly. 3.Installation is the reverse of removal
...but does not charge the battery. Sounds like the battery may have come loose in the inside. You can unscrew the back and remove and re-seat the battery, then try charging it again. Best of
...Remove the battery for 60 seconds and re-seat it back in place hopefully this will reset the processor ic, if this fails take it back because there is nothing more that can be done since the item is ...
Question about Hyundai Audio Players & Recorders
Error message " battery is too low system shutdown" The error message comes on every time I plug my device in with the USB cable. When I unplug it the battery shows 1/2 full. I can listen to radio and
...Remove the back cover (there's 1 screw on the left side. Remove it, then slide back cover to the left) Look for the ribbon connector that connects the display to the circuit board. (it's about 1 inch ...
...back, remove and re-seat the battery. Charge the device for a few hours. Best of Luck. p.s.- you can add to this question if this didnt help. i did this and it almost work up to the point where the ...
...remove the ribbon and re-seat it back in place on the board and hopefully this will fix it, because a fall can knock it out of position making you think it is plugged in and okay. Now! if this fails ...
Question about Hyundai Audio Players & Recorders
...Remove the back cover (there's 1 screw on the left side. Remove it, then slide back cover to the left) Look for the ribbon connector that connects the display to the circuit board. (it's about 1 inch ...
...remove 2 screws on side of unit(not all four, tough to get back together if you do. take ribbon and reset it into hard drive first, then unit. slide battery back on and backcover, turn on, problem ...
...Remove 2 philips screws holding circut board and lcd (Set aside seperat from other screws as shorter and must go back samme place. Fingernail out whit clip over usb port and set aside. Lift entire ...
3 questions posted
Usually answered in minutes!
14 Questions
11 Questions
2 Questions
8 Questions
9 Questions