Precor Treadmill 9.21 9.21s 9.25 9.21si 9.25 Replacement Motor Hood Cover "treadmills 10 years old" Questions

...10 years old and we have not had any problems with it. The belt recently has been going slower than before. for Example, we used to walk at a speed rate of 4.5, now it needs to be at 7.5 speed on the ...

then just stops w The treadmill is over 10 years old. Is the treadmill worth fixing; and if so. what do I need to do to fix it? This could be a number of reasons. A authorized repairer would be needed

...treadmills - at various speeds and inclines. HI, Its time to lubricate your treadmill. You must obtain the proper lubricant for your treadmill. There are several different types. Contact your ...

...10 year old. 9.31 precor. after running for 5 min. It would intermittently slow maybe halp mph. It wouldnt show it on the display. But it sounded as if the motor was slowing see the video and proceed ...

...10 minutes or so, or even sooner when I am jogging, the 921 loses power and trip my house circuit breaker. What needs to be replaced? Guessing it is the power cord as the 921 is 20 years old. I I ...

...years old. Consistently, every 4 minutes and 10 seconds it will stop & then in a few seconds resume the same speed? I have replaced the controller and that did not solve problem? Any ideas? this ...

10 years old and was just walked on per the seller. After a couple of runs, we started noticing a front end clunking sound that increases in frequency and noise. It gives no error message and seems to

...10 years old. This evening my kid were playing with it and a large exercise ball got wedged underneath the treadmill. I saw some sparks and the treadmill came to a stop. I noticed that the fuse for ...

...10 years old. We have done little in terms of maintenance (belt tightening, etc.). I didn't think this treadmill required lubrication but may be wrong about that. It has woorked fine for many ...

...Treadmills I Have 10 years old treadmill from Sportop (MT6000). recently this treadmill cannot start even the power is already ON. all Led are on. it's unable to display program on board, so ...