lennox intermitent flame problem I have a lennox furnace without a pilot lite, it will glow and the flame will start and then shut off immediatly, sometimes it works fine and then it has problems. The
Question about Dimplex Heating & Cooling
...working fine, then flame effect stopped. Heater still works on both settings, but no flame effect. Tried new bulbs, but still no flame effects, any ideas? Dimplex jaz20 optiflame electric stove If it ...
...turns on but when I switch to turn it on, Pilot turns on but when I switch to turn it on pilot flame goes off. Any suggestion? When you light the pilot, are you holding it down for 30-60
Does the burner On my Goodman PBG Package unit produce a fan shaped flame? Or, Are my burnes bad? I have flame inside the protection box where teh rollout sensors are, but the unit still works. Sounds
...flame burns against. When it is working correctly it allows gas to travel to the flame. When it goes out you get no gas, as a safety feature. Replace the therma couple and it should work again. the ...
Question about Goodman Heating & Cooling
...IT STAYS ON...THEN SHUTS OFF BEFORE TEMPERATURE GETS UP TO THE STAT SETTING... I suspect that the flame is not traveling to all the burners within a given time so the flame sensor is shuting down ...
Question about Cozy Heating & Cooling
I've got good flame replaced Powerpile pilot wont stay lit I replaced the whole pilot assembly an powerpile on a cozy floor furnace The flame sensor is not producing enough volts to hold the gas ...
GMH95, FLAME SHUTS OFF AFTER A FEW SECONDS Flame rod dirty or bad, flame tray not allowing flame to travel to all burners quick enough, look for error codes on PC Board and research code from wiring ...
Question about Heating & Cooling
RPJ 2 Comfortmaker. Turns on, runs for 5 seconds with flames then turns off. Sensor light blinks 6 times. Diagnostic instructions say check service instructions. What's wrong? on opposite side of ...
Hi My flame on a natural gas fireplace goes out 4 or 5 times until it warms up,having to re light all the time. Is this cause by a defective therma couple? Thank you Michel well depends on what flame ...
362 questions posted
Usually answered in minutes!
2 Questions
1 Questions