Razor E300s Electric Scooter With Seat "motor voltage" Questions

MOTOR IS LOSE have you checked the batteries to see if they have the correct voltage. i checked my bateries and they checked of at 13.5 volts and so i decided to check the motor well it was seized and

voltage to the motor and was ranging from 0.5 - 0.1 volts (this occurs when the scooter switch is on attempted kick start then check voltage when Throttle triggered) I then wired the battery direct to

...If you put in a new battery that has been fully conditioned and charged, then the most likely problem would be the electronic speed controller module which controls the voltage/current to the

motor doesn't even turn? Can anyone help? If thats the voltage from the 2 batteries joined together then the voltage is far too low to run an E100, sounds like one of the cells has died, must have

...voltage of the battery and make sure it reads 6volts before going to test the motor. Here are a couple links to help you get to the motor. http://peg-peregoparts.com/diagram.php?num=IGED1061 ...

...voltage from that Controller box wiring harness. If You get a positive reading out of that Controller wiring harness then the Twist Throttle thing is bad. If you get NO READING out of that Controller ...

voltage. I.e., if it uses NiCD/NIMH batteries, add additional cell. With LiPo's it's a bit complicated, if heli is running of one cell (3.7V) adding another cell will burn it. If it is 2 cells, trying

...motor as it's better and less frustrating to just buy a whole new set. Finally, the problem may lay in the power pack (inverter) itself. I personally don't bother trying to fix a power pack, but if ...

size- to polish the surface of the commutator and brush so that there is EVEN seating which will allow the motor to work even with low voltage. Please check alignment when it is set back.    

...and battery tray to get to it. If the motor isn't spinning, check the motor by applying voltage to it. If that works, swap out the receiver. I've gone through all of the above over the course of