Question about Kenmore HE2 Washing Machines
...drum to check? You have to separate the front and rear of the tub to get at basket, which is a major job. You might take a flash light and look through the holes in the basket to see what's
...basket. remove front kick panel or rear panel and remove large hose from bottom of tub. clip usually positioned in rear. if unit with heater then heater and clip can be felt inside tub. check inside ...
Question about Kenmore Washing Machines
...TUB THE BASKET IS RUBBING ON THE PLASTIC FRONT TUB AND TEARING IT UP. HOW DO YOU REPAIR THIS AND HOW MUCH SHOULD IT COST ? SHOULD I JUST BUY A NEW WASHER ? if ripped obvioussly youl need to replace ...
...I noticed that the front of the basket is not centered on the front half of the tub. It appears to be sitting higher than centered. Be sure both lower and upper halves are correctly connect ...
...certain level and water leaks out Sounds like the outer tub has a hole in it. Some of the newer models had a problem with the inner tub (basket) would rub a hole in the outer tub about 2/3 the way
basket, allowing it to be off center, dragging the bottom. one of the welds on your inner stainless steal tub may have broke causing the drop of your tub. The tub has a warranty on it but the labor to
basket rubbing on tub. what is the correct position of the basket drive block in relation to the spin tube? mine was 1/2 inch down from the top of the tube. there does not appear to be any stop other ...
Question about Kenmore HE2 Washing Machines
...basket and tub. Then I found, looking at the front of the tub, inside the door, behind the gray rubber flange, that pieces or the rim of the plastic tube, right near the front of the stainless steel ...
Question about Whirlpool Washing Machines
...tub from the inner metal basket rubbing on it during the spin cycle. I got some plastic cement and put it in there and it willl hold for a little while while anyway. Not a very well designed washer ...
...basket and front outer tub assembly. Likely, the spider on the inner basket (drum bracket) has broken which is causing it to be loose and rubbing on the inside of the outer tub. This can be verified ...
2,986 questions posted
Usually answered in minutes!
11 Questions
12 Questions