I need to change my brake fluid on my 2001 zx6r. How do I do this?

If it is near the tire it is brake fluid. The brake fluid reservoir is back by the firewall driver side of engine compartment. Your car uses DOT 4 brake fluid.

check your master cylinderr fluid level. If full brakes may be worn badly or master cyoinder may be going bad.. if brakes are ok change brake sending unit usually located on master cylinder. do noty drive until you are positive your brakes are good. if fluid level is low in master look for brake fluid under car usually on back of wheel.if no brake fluid on back of wheel inspect brake lines for a hole usually rusted through. if this is helpful please leave me positive feedback.

brake fluid will get lower in the reserve as your brake pads wear. if it is really low u should probably take it in to have the pads changed.

Mostly there are no lights and no problems with bleeding abs brakes - the brake pedal has to be pumped full stroke after replacing brake pads or servicing the brakes and that doesn't usually cause problems though there are no absolute guarantees.

Try this manual, it should cover all your needs. Are you sure you have the correct rating fuse in the box, the manual will solve the problem any way. Good luck:

http://vitek.vellum.cz/manualy/Kawasaki%20Ninja%20ZX-6R%2000-02%20Service%20manual.pdf

Change front/rear axle oil
Change transfer case oil
Air filter
Engine coolant
Rotate tires
Fluid level on battery/radiator/brakes
Change oil and filter
Inspect for fluid leaks
Inspect coolant and heater hoses
Check exhaust system
Check drive belts/tires/wheels/brake lines
Check steering operation/disc brakes/brake pedal play
Check parking brake
Check and lube accelerator linkage
Check suspension/steering/power steering fluid
Lube body and chassis
Check TOD system fluid
Check cruise control linkage and hoses
Check starter safety switch
Lube key lock cylinder

"tried changing the brake pressure warning switch"

Did you actually change it or just try? Be more accurate ***!!

every two years need to change brake fluid.

the horn is only held on by 1 bolt,undo this and remove the 2 wires then just reverse these steps to refit