Cluch needs ajusting it wont ride smoth on first geare with the cluch out

check safety swith it"s under the seat, my need ajusted also if your suppose to push the cluch in to start it check that switch, on some bodies there is a safety switch on the Trany buy where the shifter go's in to trany. gl

trans oil low level,oil presure to low or oil presure to high1st ajust the cable for trans or the bens front cluch.

Sounds like the clutch plates may be stuck together. Happened to me after a long trip in the rain and bike sat for a few weeks after that. Had to take the cluch discs out and clean them

try re-posting, you got cut off. be specific.

The preload for the shocks is on the shocks themselves which are under the bike make sure you turn them both in the same amount.2nd problem could be your clutch needs adjustment and or you have to much primary fluid in it.You should only fill the primary to the botttom of the diaframe spring to much creates drag and if cluch is out of adjustment creates drag

your cluch is not disengaging when you step on the pedal check ajustment on cable tighten cable and try again...good luck

oh dear, you drive with your foot on the cluch then? or hold the cluch down at the lights insted of knocking it out of gear? never hold down the cluch for more that 30 seconds at a time,,,,,naughty naughty! this is just one of the prices you pay for that,
its you cluch release bearing, its seised up on you, cluch riding dose that! its only a little bearing!!!!!
the fix is a new cluch bearing, but what it costs to take the gear box out to replase the bearing it would be cheeper in the long run to have a compleat new cluch fitted, and then lurn not to ride the new cluch as much,,,,and all this just to pull away a fuw seconds faster??? this is a £350-£500 job now
how frustrated do you feel now?????

if adjusting cable tighter helps, then try replacing the clutch pack(plates). if not then try replacing worn springs.

you need a new flywheel...basically you need to replace your clutch.

Adjust in gear 7. If you try to adjjust in gear 1 you will get it to tight and it wont work properly