Questions & Answers for: ajusting cluch

cluch is slipping after changing it the cluch was slipping, so i put a new cluch kit in but it is still slipping and more so now, is there an ajustment on the cluch and wear? everytime you change a ...

Ad

Question about CAM2752KQ Top Load Washer

1 Answer

whirlpool washer beltdrive won't spin how do i whirlpool washer beltdrive won't spin how do i ajust the cluch . it was sqeeling when it went to spin so i tightened the belt and i may have missed up ...

Ad

how do you ajust cluch for ls 650 suzuki(cabel not how do you ajust cluch for ls650 suzuki(cabel not the problem) if adjusting cable tighter helps, then try replacing the clutch pack(plates). if not ...

I just ajusted my cluch, and now I dont have petle, can you tell me just how to ajust my 2002 kio cluch. Should be hydraulic. Try bleeding again to get all air out. how did you adjust it ?

SR125 Clutch lever awkward for a small hand to operate. The span on the clutch lever of my daughters Yamaha SR125 is too wide for her small hands.I wondered if a straighter or smaller span lever from ...

Question about 38-Inch Steel Deck 15.5 HP Briggs & Stratton I/C Engine With 5 Speed

2 Answers

poulan riding lawn mower starts but won't shift into any gears your cluch is not disengaging when you step on the pedal check ajustment on cable tighten cable and try again...good luck where do you ...

Question about 2000 VL 1500 Intruder LC

1 Answer

cluch ajusting cant get in to 3rd 4th gear it moves foward with the cluch all the in try re-posting, you got cut off. be specific.

Question about 2000 VL 1500 Intruder LC

1 Answer

the 1234 knob on the cluch handle does that ajust the cluch no, only how far in the handle rests(for adjusting to smaller hands) if you have a hydraulic clutch, all you can do is bleed it. if it is a ...

My 1997 hyundai elantra won't start, over the last two weeksI have had to really push hard on the clutch to get it started, then it just wouldn't start at all. Battery is fully charged and starter ...

Question about 1990 FZR 600

1 Answer

cluch needs ajusting it wont ride smoth on first geare with the cluch out sir , if your bike clutch release on the end ,then bike began to move..then you need replate its clutch plates, otherwise ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...