Suzuki marauder 125 oil change

Question edited for clarity.
Question moved to model category.

2006 GZ125 Valve Clearance *update

Bike Chat Forums https://www.bikechatforums.com > viewtopic
Sep 29, 2012 · 7 posts · 4 authors
Now, according to Haynes, the clearances on the valves should be between 0.003" and 0.005". To me, that means 0.004" should be just about bang ...
Missing: 2003 ‎specs

• 
  

  suzuki gz 125...lack of power?????

  https://www.bikechatforums.com > viewtopic
  Oct 19, 2012 - Valve Adjustment; you can check the clearances make sure that they are at the right amount. Always good to check this.

Full parts list just because I found it.

http://www.motocykle125.pl/wp-content/uploads/2016/02/suzuki_gz-125_125cc-gz125-ap131-1998-2000.pdf

Service Manual

https://www.google.com/search?q=2003+suzuki+marauder+gz125+service+manual

..

125 seat
https://www.boonstraparts.com/en/parts/mke=suzuki/mdl=gz+125+marauder+1998+2006/prt=seat-front

800 seat looks similar. Seat framing must be same size. Any seat can be made to fit.

https://www.google.com/search?q=Suzuki+Marauder+800+seat

..

DRAIN OIL INTO SUITABLE TUB REMOVE OIL WINDOW IF IT IS MOUNTED IN A NUT CLEAN WITH WD40 FLUSH ENGINE THROUGH WITH PETROL OR PARRAFIN REFIT OIL WINDOW AND SUMP PLUG REPLACE OIL FILTER REFIL ENGINE WITH NEW CLEAN OIL TO MAX LEVEL START ENGNE RUN FOR A FEW MINUTES SHUT DOWN RECHECK OIL LEVEL AFTER 15 MINS TOP UP IF NEEDED JOB DONE

Won't start 2008 Suzuki Marauder GZ125. The starter switch does not work every time when it doesn't I switch off give it a few seconds try again sometimes it works others it doesn't I try waggling steering sometimes that helps.

http://www.cmsnl.com/suzuki-gz125-2000-cy_model13790/partslist/

Go to the above site and scroll down to the section required (either front wheel or brake) An exploded view with ALL parts is shown with arrows for placement. Cheers

hi buddy the picture below will show you the mixture screw unscrew this 1/2 of turns out if still no difference unscrew another 1/2 if getting worse screw in 1/1/2 turns it just play with it budd this is the screw that puts the correct amount of fuel with the air

http://cgi.ebay.co.uk/SUZUKI-GZ125-MARAUDER-GZ125W-ENGINE_W0QQitemZ300322833799QQcmdZViewItemQQptZUK_Motorcycle_Parts?hash=item45eca2c587&_trksid=p3286.c0.m14&_trkparms=65%3A12%7C66%3A2%7C39%3A1%7C72%3A1689%7C240%3A1318%7C301%3A0%7C293%3A1%7C294%3A50
£250 on ebay