How much oil with a filter change does a 2010 vstar 1300 take

Try checking the ignition itself (where your key goes), then ignition coil. also check relays, bad/bare wires, bad ground etc. etc. However, don't just go throwing parts at it hoping one sticks. Get a multi-meter and do it right.

Electical issues can be a pain.

under the riders seat

If you need further help, I’m available over the phone at https://www.6ya.com/expert/robert_beef7390c57fac0d

I use fram PH6017A. Get them at wall mart 6 or 7 dollars. about ten.or twelve dollars cheaper than one from yamaha also longer than stock so insted of 3.6 qt of oil I use full 4 qt. Hope this helped. Ride safe and have fun

Oil drain plug is located near the bottom of the engine, left side toward the front. The oil filter element is located on the right side of the engine under the cover toward the front. Changing the oil filter usually requires removal of the front exhaust pipe. There is an aftermarket filter relocation kit that replaces the filter element with a spin on filter that mounts on the front of the bike.

VSTAR 1300 HOLDS 3.38 US QTS WITHOUT FILTER CHANGE AND 3.59 US QTS WITH THE FILTER CHANGE.

i think the oil filter is at the front behind a round finned cover, if you find the drain plug it should be right above it, it shoud tell you how much oil it takes right next to the filler