Switch right side under seat.
SOURCE: 93 Dyna low rider fork oil.
your local hd shop should be able to answer this for you as its a mesured amount and to much or too little will make the bike not handle right
SOURCE: how to change primary chain tension on 2007 Harley
Sorry, not up on new hogs but I think you remove plate off outer primary,it's got the foot peg mounted on it.Look through hole and you'll see the bolt that holds the chain support unit.Carefully loosen bolt and pry up or down,tighten or loosen, tension.You don't have belt right? some newer ones do.If you want hi-tech and yours doesn't have one already remove the outer primary and replace the "skidplate" adjuster with a roller type.Makes things quiet.There is room in the hole to check that you don't get chain too tight.
SOURCE: how to remove starter clutch on a 1998 Dyna Low
The starter clutch is an integral part of the starter assembly itself. You must remove the starter and disassemble it to get the "overrunning clutch" out. First take the starter off the bike. Then, remove the two long bolts and take the starter motor off of the drive housing. Then remove the bolts that hold the drive housing together. The overrunning clutch will come out of the drive housing. You will probably have to take the bearings off the original clutch and reinstall them on the new part. Reassemble the starter and reinstall it on the bike.
SOURCE: Transmission filler plug wrench size?
I haven't looked at a 09 model but earlier models used a 7/16 inch allen key.
SOURCE: Where is FXDL dyna low rider gas filter located ?
Inside Gas Tank... Also Check Carb.. Or Download Diagram From Internet... Type On Google Exemple.. Download Harley FXDL Dyna Low Rider 2005 Repair Manual .. good luck
336 views
Usually answered in minutes!
×