I know there's a switch that connects to the foot brake. Have I put it back together wrong?
Check the bulb first if stayed on gets hot and blows easy. then if staying on adjust the switch
will try and get back to you. Thanks
I just realized I also have no headlights. When I turn the key to "on" there are no lights at all. When I turn the key to "park" the tail lights come on. Does the bike have to be running for the headlights to work? Still no brake lights either
some bikes the headlight only comes on whilst engine running
OK Thanks
×
SOURCE: Brake Light Fuse Box
look for the fuse box just forward of the radiator. it should have the other fuses you are looking for.
SOURCE: Suzuki VL intruder 125 back brake sticking and braklight stuck on
i too had this problem .....dnt worry just remove the brake cable and lubricate it with some spray like ABRO or WD40 lubricating spray then you sprayed some in the cable.play with it pull it forward and push it backward.,lubricate and repeat the steps till you find the cable goes smoother...you know it usually happens due to dust and dirt which enters the cable n get it stuck,try this n tell me..
SOURCE: just replaced clutch spring on '01 vulcan 1500
assuming it was reinstalled properly....try the following. while bleeding the system, squeeze the clutch lever several times to pump up the system as normal; open the bleed screw while holding the clutch lever in and air or fluid comes out. instead of closing the bleed screw hold your finger over the bleed screw and pump up the clutch lever in the normal fashon and bleed by releasing your finger to let the air escape try this several times to see if your clutch comes back. I don't know why but this technique works sometimes...Mike...Make sure you always have plenty of fluid in the resivoir at all times
SOURCE: Fork oil capacity for a 2005 kawasaki vn1600 mean
Hi Des, Im am Irish too, howya doin? The oil you want is SAE 10W-20. and 445ml if you are changing the oil. It can be more accurately checked with the fork removed and fully compressed and the spring removed, the oil will be 120mm from the top ot the stanchion.
The manual will give you more info on this and any other future problems so here is a link to it. Good luck to ya, and please rate me if I've helped you. Thanks
[email protected]
VN1600 manual...
http://www.scribd.com/doc/9607829/Kawasaki-VN1600-A1A2-Vulcan-03-Service-Manual-ENG-by-MosuenoPW
SOURCE: Where is the fuel filter located on a Mean Streak?
Not sure if the same but my 1996 1500 Vulcan Classic is under gas tank
145 views
Usually answered in minutes!
×