Replaced f/pump pressure regulator but pump keeps oncutting in and filled both cylnders with petrol . anybody encountered this before
SOURCE: trouble starting, keeps cranking, backfires,replaced
if you at any point have changed you´re timing belt you might have timed it a tooth or two of
SOURCE: fuel pump pressure
In my experiences over the years pressure testing the carbs and messing with the fuel pump, I have never actually tested the pump output. Knowing that the average pop off pressure of the float valve on the float is 10-13 psi, this being tested via hand held pressure gauge to ensure no leaks before installation on the bike. I assume that the fuel pressure coming from the pump should not exceed the pop off pressure or it could cause the carbs to leak though and the bike would run rich. Hope this helps out.
SOURCE: Fuelpump failure on ZZR 1100 C Model
hi deon,, in theory u can use any fuel pump on bikes,, most pressure is the same on all makes, wen the carbs are full of fuel the will shut off automaticly,,so yes u can use an after market one,,,cheeeers
SOURCE: fuel pump not priming
check the cdi in suzuki when goes bad some times the pump does not work.
88 views
Usually answered in minutes!
×