20 Most Recent 2008 Suzuki GSX 1300 R Hayabusa Questions & Answers

i would check the starter relay and fuse.

autozone.com

maybe it is, change the plugs use tungsten. eBay

NGK Iridium Spark Plugs SUZUKI GSX1300 HAYABUSA X4

• Watch this item
• See seller's other items

• £26.92 Was: £28.34
• Free Postage
• >127 sold

ring Suzuki dealer

such as what????!!!! more info pls

Most probably the battery has shorted out. Check all fuses then fit a new battery if you re lucky the battery is the only thing that has fried. If nothing works when your new battery is fitted check the regulator/rectifier and further back to the alternator if necessary. Please never use jump start packs or car chargers to start your bike. Also never jump start from a car etc. using cables. Your poor little battery is not designed to take the amount of the current these units give out. Only use a dedicated bike battery charger with an output of 1 Amp maximum. Please also when removing the battery undo negative first when refitting connect positive first.

DONT run any more till you can figure out problem, probably a faulty seal or O RING

Instructions

1. • 1 Remove the rear cowl using the ignition key. Use the 5mm Allen key to remove the two bolts securing the seat to the frame. When the bolts are out, lift up at the back and remove the seat.
   • 2 Remove the prop fuel tank prop rod from the rear storage area. Lift the back of the fuel tank and support it with the prop rod.
   • 3 Unplug the fuel injector wiring harness connector. This is a white connector that has wires coming from the fuel rail and connects to the main wiring harness.
   • 4 Locate a spot in the rear storage area to mount the Power Commander unit. Clean the spot using brake cleaner and a rag. Mount the Power Commander unit to the spot using the Velcro tape supplied with the Power Commander.
   • 5 Route Power Commander's wires along the frame rails towards the front of the bike. The wires from the Power Commander have two connectors. Plug each connector from the Power Commander to the white connector you unplugged in Step 3. The connectors will only plug into each other one way.
   • 6 Lower the fuel tank and reinstall the seat. Start the engine and follow the procedures for programming the Power Commander according to the instructions in the manual.

Is the gas new?If it isn't,there was a report about how ethanol is causing problems in gas lines and motors.It erodes the non metal parts in the fuel system.You can try cyphoning the gas,add octane boost,then add some gas.My mechanic recommended it because I was at wits end and out of ideas so I called.A couple gallons is fine because if it doesn't work,you won't waste much money.I had the same problem,same time sitting on a scooter and it didn't work.It's all I got for now.Isn't it WONDERFUL that we're going green?
Good luck bro!

repleace your trun signal switch

2nd gear is bad and so are you shift frok

The right side

normaly find this under rear seat stuck to frame.