Top 20
2011 Aprilia SR 50 R Questions & Answers
Will not start Aprilia Mojito Custom
OK< can you provide more details? Does it turn over? Does it fire at all? Do you know if you have a spark? Do you know if fuel is getting through? Has it run properly recently?
To run, a motor needs fuel, air and spark
Inspect all fuel lines and wires. Pull the sparkplug and see if it is burnt/wet/corroded
11/20/2019 10:36:25 PM •
Aprilia...
•
262 views • 0 helpful votes
I have installed a new ignition on y aprillia pegaso 2008 and it wont accept the code numbers
It's not the new switch, it's the new keys that have to be programmed.
The keys have uniquely coded chips in them, when you turn on the ECU uses the antenna that is by the ignition switch to look for a code that it recognises, you need to introduce the new key codes to the ECU.
This is what the manual says:
In case of installation of a new ignition switch the procedure is as follows:
Turn ON using new key
The dashboard will not recognise the key and will ask for the customer code: insert the customer code. It is 00000 when supplied. It can be changed to any numeric five digit number.
Now you can enter: MENU, DIAGNOSIS (insert the service code 25973),
Then select MODIFY KEYS and implement the procedure.
If you are not sure about the mode switch, this is what you do:
Use handlebar "mode" switch (left / right) to select "Menu" option on the screen, then press mode switch in to enter.
Use handlebar "mode" switch to select "Diagnosis", press to enter.
Use handlebar "mode" switch to enter the workshop code (25973).
When you have selected the digit you want then press in and it will move to the next digit etc.
You can't screw anything up, if you do it wrong go back or turn off and start again.
2/24/2019 8:21:45 PM •
Aprilia...
•
384 views • 0 helpful votes
Do you put water in a Aprilia Leonardo 125 2009
The coolant system on any engine, including bikes and scooters, does not use just water. You will need a coolant mixture which you dilute with water. There are several types of coolant mix so it would be a good idea to ask an Aprilia specialist exactly which type of coolant mix to use.
9/27/2018 3:12:37 PM •
Aprilia...
•
89 views • 2 helpful votes
Aprilia Fault Codes
Component
|
Fault Code
|
Possible Cause
|
Camshaft position sensor
|
11
|
Sensor not connected.Sensor broken.
Wiring faulty.
|
Crankshaft position sensor
|
Intake pressure sensor
|
Intake pressure sensor
|
14
|
Excessive pressure difference between two pressure sensors
|
Throttle position sensor
|
15
|
Sensor not connected.Sensor broken.
Wiring faulty.
|
Coolant temperature sensor
|
Air temperature sensor
|
Atmospheric pressure sensor (inside ECU)
|
23
|
Sensor faulty
|
Ignition coil 1, Front cylinder
|
33
|
Ignition coil faulty or wiring not connected
|
Ignition coil 2, Front cylinder
|
Ignition coils 1 and 2, Front cylinder
|
Ignition coil 1, Rear cylinder
|
Ignition coil 2, Rear cylinder
|
Ignition coils 1 and 2, Rear cylinder
|
Fall Sensor (tip-over sensor)
|
41
|
Sensor not connected.Sensor broken.
Wiring faulty.
|
Source
Aprilia Fault Codes
Not finding what you are looking for?