Cars & Trucks Logo
Posted on Aug 22, 2008

Water pump replacement procedure 2005 2500 dodge with cummins diesel

What is the proper procedure for replacing the water pump on a 2005 dodge 2500 4x4 with the cummins diesel

  • 1 more comment 
  • Anonymous Aug 30, 2008

    I have a need for a picture of the serpentine belt route and the pullys. When my water pump went out it destroyed pullys and the belt. Need to "see" what it all looks like when its together.

  • Anonymous Mar 12, 2014

    need a serpine belt routing diagram for 2005 dodge 2500 cummins turbo diesel with p/s and a/c

  • Anonymous Mar 17, 2014

    2007 dodge cummins 6.7 alternator not charging,, replaced alternator

×

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

Corporal:

An expert that hasĀ over 10 points.

  • Contributor 3 Answers
  • Posted on Mar 22, 2009
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Corporal:

An expert that hasĀ over 10 points.

Joined: Mar 22, 2009
Answers
3
Questions
1
Helped
2946
Points
16

Take off old water pump. clean up area on the motor real good.do this by using a scrapper and cleaning slolvent. when thats all done put hi temp silicon on the block water pump and the put gasket on silicon. let dry for like five minutes. put in on torque bolts to specs.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

What is the fuel pump pressure for a 91 dodge Cummins diesel?

what cummins diesel engine model is in the dodge
cummins make a large range of engines all of which have various pump pressures depending on the injector set up
ask your question again and concentrate on the engine details
0helpful
1answer

Is there a difference between a $60.00 water pump and a dealership $474.00 water pump for a 2005 dodge dielsel

Hi,
if you have a Cummins diesel then it probably has a geardriven water pump. Dodge gas engines have a belt driven water pump, much cheaper. Check around for a re-man water pump if you have a Cummins installed. The prices vary enormously.

Good luck.
3helpful
1answer

A diagram for changing the water pump on a 2006 dodge ram 3500 cummins diesel

On a cummins turbo diesel the water pump replacement is quite simple i do believe. just have to remove the belt. The clutch fan, and pulley, then the water pump is right there i believe being held on by 4 bolts only and remove. Remember to place the wate pump o-ring on the water pump and hold in place with sort of adhesive just to make sure it doesn't slip out during installation or this will cause a leak. Once everything is installed then you will need to purge the cooling system of the air bubbles by letting it run and watching when the thermostat opens up. You can tell because the level will drop in the rad or over bottle, depending on what controls the fluid. Let it open two or three times, and go for test drive, all should be well...hope this helps
0helpful
1answer

2003 CUMMINS STALLS BELOW 1/2 TANK RUNS FINE ABOVE 1/2. REPLACED IN TANK FUEL PUMP MODULE STILL HAVING SAME PROBLEM

Just a suggestions but...

Check fuel filter.

Also add some fuel conditioner (e.g. HEAT for diesel) to get rid of any water that may be in your system.

6helpful
1answer

Water pump needs replacement.cummins diesel

the water pumps on these engines are some of the easiest to replace. just take the belt loose. unbolt the water pump and pull it out. scrape whatever pieces of the old gasket are on the block off. and install new water pump and gasket. the put the belt back on.
here is a better demonstration with pics:
http://www.cumminsforum.com/forum/3rd-gen-tech-articles/182382-water-pump-thermostat-replacement.html
0helpful
1answer

1999 dodge diesel 2500 seems to have a fuel related problem.

Please clarify the "loosing power" does it lose power and shut down or does it loose power but will idle? Your Cummins is electronically controlled so oil condition is important, fuel leaks, oil leaks, leaks in the air ducting between the turbo and the intake, sensors, water in the fuel. Do you get an engine light when this trouble happens? Dodge uses a lift pump to carry fuel to the the injection pump, is it working?
Not finding what you are looking for?

2,102 views

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...