I have power rear vents on my 98 Villager that does not operate. I cannot locate it on the fuse box to replace so i checked each fuse and none were blown. Where is it?

The following components are used to control the power windows:
• Driver door module (DDM)
• Passenger front door module (PDM)
• LH rear door module (LRDM)
• RH rear door module (RRDM)
• Driver door switch assembly (DDSA)
• RH front power window switch
• LH rear power window switch
• RH rear power window switch
• LH front power window motor
• RH front power window motor
• LH rear power window motor
• RH rear power window motor
• Class 2 serial data link
• DR MOD PWR C/B 30 Amp circuit breaker
• DRIVER DR MOD 10 Amp fuse -- DDSA and DDM logic, DDM internal driver operation.
• PSGR DR MOD 10 Amp fuse -- PDM logic and internal driver operation.
• REAR DR MOD 15 Amp fuse -- LRDM and RRDM logic and internal driver operation

There isn't one. Cruise Control is a joint computer operation by the BCM and ECM.

Mercury Villager (1999-2002) fuses and relays

Fuse Box Diagrams https://fuse-box.info > mercury > mercury-villager-19...

Here you will find fuse box diagrams of Mercury Villager 1999, 2000, 2001 and 2002, get information about the location of the fuse panels inside the car, ...

https://www.google.com/search?q=mobile+auto+electrician+near+me

..

Engine compartment main fuse panel 30 AMP fuse Fuse #4 scroll down and look at this diagram picture on this link. http://www.autogenius.info/mercury-villager-1st-generation-1993-1998-fuse-box-diagram/ caution, this fuse runs power seats, windows and sun roof as well.

Mercury Villager 1st Generation 1993 1998 fuse box diagram Auto Genius

Check all your wires ,make none have rubbed and exposed the bare wire .vibrations might cause the wire to short out on metal

You can research "Villager fuse box diagram" online and get the photos, the washers are on the same fuses as the wipers, number 8 for the front and 9 for the rear.

Hi,

Thanks for using FixYa!

If the rear power windows don't work. Its possible that you have a blown fuse for the rear side windows. Open up the fusebox usually located under the dashboard. Check the fusebox manual. Locate the fuse for the rear power windows. check if the fuse is blown. Replace the fuse. im 98% sure that its just a blown fuse.

Have a wonderful day.
- HotRatchet

There may be an adjustment on the switch, not sure, but hope it helps a little

If you have checked all your fuses and the brake light bulbs are good then the brake light switch might be bad, it should be located on a bracket at the top of the brake pedal. when you press on the brake pedal it pushes this switch in to activate the brake light's.

Open the rear hatch. Pull off the inner trim panel. Look to see if there is a little box with a bunch of wires connected to it. It may be at the lower edge, driver side. Turn the key on. Test for 12 volts at the solid BLUE wire (there is only 1 solid blue wire) that is connected to the box. Is there power? If not, check the 30 amp POWER fuse. If there IS power, this box may be bad. This is the power window relay for the rear hatch. The wiper/washer and the rear window motor power all come out of this box.
BUT:
Check for power & get back to me before you buy a relay box, there are a few other tests I could share with you before we pronounce the relay box bad...