Geo metro timing diagram

Hello hjolana: My name is Roger and i will help you. I have attached a picture of the timing marks.The camshaft mark aligns with the mark at top of cover behind the cam gear. The lower mark aligns with the notch on the block and the crankshaft key way is at 12:00 o'clock. See the picture. Should you need further help please just ask. Please rate the answer. Thank You for using Fix Ya. Roger

My sincere apologies for the severly delayed response.
I am personally going back to answer your unanswered questions.

I do not know if you still need this information, however I am answering it in case you still do.


Click on the following direct Link. It has the Timing Belt Diagrams with Marks for the Camshaft and Crankshaft that you will need.

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com

http://www.2carpros.com/car_repair_information/year/1989/make/geo/model/metro/1989_geo_metro_timing_belt_diagram_marks.htm

From the book
crankshaft sprocket has a slot which must align with the key in the crankshaft
The mark on the lower timming belt sprocket must align with the mark on the engine front cover.
Pictures worth a bunch of words (email).

Sorry for the severe delay.
I am personally going back to answer your unanswered question.
I do not know if you still need the answer, but I am going to answer it in case you still do.

Click on the following direct Link. It has the Timing Belt Diagrams with Marks for the Camshaft and Crankshaft that you will need. It also has schematics on cover bolt/nut locations.

Again my apologies...
Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

http://www.2carpros.com/car_repair_information/year/1991/make/geo/model/metro/1991_geo_metro_timing_belt_diagram_marks.htm

1996 Geo Truck Tracker 2WD 1.6L MFI SOHC 4cyl



Fig.: Before installing the timing belt, position the camshaft sprocket (1) so that the timing mark on the sprocket (2) is aligned with the notch (3) on the inside timing belt cover (4) ...



Fig.: ...and ensure that the crankshaft sprocket (1) timing mark (2) is aligned with the mark on the oil pump (3)

For more details, can register in autozone.com (free).

I hope help you with this (remember rated this help) Good luck.

1986 Dodge Truck RAM 50 4WD 2.6L 2BL 4cyl

Fig. Timing belt and components-2.0L engine



Fig. Location and correct alignment of timing marks for the timing belt (camshaft)



Fig. Timing marks-2.3L diesel engine



Fig. Timing marks-2.4L engine



More details, autozone.com (free register). Good luck.

The timing marks are as follows
1. there is a "V" on the cylinder head cover.
2. Timing mark on camshaft timing belt gear
3. "Arrow mark" oil pump case
4. Punch mark on crankshaft gear.
DON'T MESS UP! THIS IS AN INTERFERENCE FIT ENGINE! IT WILL BEND VALVES!

a repair manual will show you the specs you need

alldata,com can get you a full instruction book online.

I just did my 95.
The bottom outside pulley has a little cut in it,and its little.Line that at 5 degrees the 3rd line on the plastic marker.
Now on the cam,there`s 2 marks.use the one that has the nipple under it and line it with the v on the back plate.

and wala.