Need ignition wiring diagram car will not start

Have you voltage drop tested and OHM tested the coil with a multimeter, to confirm it's operating within specification?

Here's the ignition wiring diagram:

Identify Components: Before starting, make sure you have the ignition switch and necessary wiring harness.

Disconnect Battery: Ensure the battery is disconnected to prevent any electrical accidents.

Locate Ignition Switch Wiring Diagram: Obtain a wiring diagram for the ignition switch and the Caterpillar 3116 engine. This will help you identify the correct wires to connect.

Mount Ignition Switch: Mount the ignition switch in a convenient and secure location within the vehicle.

Connect Wires: Using the wiring diagram, connect the wires from the ignition switch to the corresponding terminals on the Caterpillar 3116 engine. Typically, the ignition switch will have terminals labeled for various functions such as ignition, accessory, starter, and battery.

Test Connections: Once the wiring is completed, double-check all connections to ensure they are secure and correctly wired.

Reconnect Battery: Reconnect the vehicle's battery.

Test Ignition: Turn the ignition switch to the "ON" position and verify that electrical components such as lights, gauges, and accessories are functioning properly.

Start Engine: Attempt to start the engine and ensure that the starter engages and the engine cranks properly.

Final Checks: After successful installation, perform a final check of all connections and ensure that there are no loose wires or potential electrical hazards.

For every car ever made that ever had an ignition lock?!?!

Google

year make model ignition wiring diagram

and you will find it.

2006-2008 Honda Civic Vehicle Wiring Chart and Diagram

http://www.commandocaralarms.com > wiring > civic
Commando Car Alarms offers free wiring diagrams for your 2006-2008 Honda Civic. ... View our complete listing of wiring diagrams for your Honda Civic.

Honda Civic DX 2008 - SYSTEM WIRING DIAGRAMS

https://portal-diagnostov.com > 2020/04/07 > starting-c...
Apr 7, 2020 - STARTING/CHARGING - Honda Civic DX 2008 - SYSTEM WIRING DIAGRAMS Remote Starting Wiring Diagram, Canada (1 of 3). Get Access all wiring ...

..

Use a test lite on negative side of coil, engine cranking, the lite should pulse?
It appears the vehicle has electronic ignition, There is a separate ignition module. In the wiring diagram, I can't guarantee the wire colors. The older my wirings diagrams are, it seems, the less accurate they are. I hope it is readable, If no spark, I'd check the ignition system, Check fuses--fusible links--battery connections.

You'll need the ignition wiring diagram for your specific vehicle. Disconnect the electrical connector for the ignition switch, then you'll need to identify which wires are which. Once you've got that you have to jumper the wire with battery voltage (12v) to the wire for the run position. Once those two have been connected, momentarily jumper the 12v wire to the "start" wire this will cause the vehicle to crank and start up. Once it starts remove that second jumper. Leave the 12v connected to the run wire, remove it to shut it down.

Fixya doesn't have wiring diagrams. Sorry

Try this site it has the diagram for 83-88 bronco 2s.......

http://www.auto-wiring-diagram.com/1258-start-ignition-wiring-diagram-of-1983-1988-ford-bronco-ii.html

when looking at it from the front the most left is from the battery, now going right from there the little pin is from ignition, basically to flip this giant switch on. next little pin goes to your fuel shut off relay, it will turn on that relay to send power to your pump while cranking, next is the large out. far right. that goes to your starter.

there should be a slot for each wire on back of ignition play with them till you get it right cant hurt anything

My 1992 Chevy blazer s-10 starts and then the door locks automatically starts locking and unlocking...It wont stay running either...