How to adjust headlights on 1995 chevy blazer
The adjustment screws/nuts should be located either on the top of the headlamp assembly,
behind the headlamp assembly, or near the frame rail by the radiator
support.
You will have vertical adjustment screws for each independent beam
(separate highs and separate lows, but will be same screw if highs and
lows are the same bulb). You may also have additional horizontal
adjustment screws as well
Park
your car on a level ground 30 feet from a wall and measure the height
from the ground to the bulb and mark on a wall (do this for highs beams
and low beams if the bulbs are separate, if highs and lows are the same
bulb, only do it for the lows)
For Low Beams: If the headlights read VOR, then
aim the brightest part or cutoff part just below the mark on the wall.
If it says VOL or nothing, aim them 2 inches below the mark on the wall.
For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.
HAVE AN O4 BLAZER & I REPLACED THE STOCK BULBS WITH THE NEW SUPER BRITES. BOTH LOW & HI BEAMS POINTED UP & INWARD. TOOK BULBS BACK TO RETAILER & SWITCHED FOR DIFFERENT BRAND, NOT AS BAD. YOU HAVE TO LOOK OUT FOR THE INSIDE COATING ON THE BULBS WHICH ALTER THE BEAM AS OPPOSED TO THE STOCK BULBS. THE NEW REFLECTOR BULBS ARE NOT ALL THEY ARE CRACKED UP TO BE. WOULD LIKE TO SEE THE HI BRITES IN ASEALED BEAM. BLZR-OWNR
×