SOURCE: set timing 1997 jimmy
Ok that's pretty simple Put cylinder # 1 on TDC= top dead center on the (compressionstroke piston all the way up). Mark on metal part of distributor (with marker) where the number one is on the cap( that's where the number 1 wire plugs in) Then in-plant distributor make sure that rotor point is pointed to #1 on the cap, turn distributor shaft until this is achieved or as close as possible try to center shaft so you can adjust... ****** or advance to fine tune after you in-plant distributor if needed. Contact if you need more help . Good Luck
SOURCE: need to replace passenger side view mirror 200 GMC Jimmy Diamond
On my '97, there was a triangular shaped piece of plastic on the inside trim that had to be removed. I think all three mounting screws were under that. It's been a few years, but I think that was how it was done.
I remember it was pretty easy though.
SOURCE: 1999 gmc jimmy rearview mirror diagram needed
It should just slide out. You might have to use a little bit of force
110 views
Usually answered in minutes!
×