Use your meter to check for power at the clutch switch when the key is turned to start. If no power, the ignition switch or wire from the switch is bad. If the is power, the starter solenoid is bad.
Do It Yourself Diagnosis and Repair
SOURCE: 1992 Mitsubishi Eclipse transmission slips in overdrive
well the low cost way to go first would be to try and change the trans fluids. If the problems still remains the it may be an internal problem
SOURCE: Hi i have a mitsubishi lancer 1.3 petrol 2006, i
wow ok i am from australia our lancers only come in a 2.0 or 2.4 i was shocked to see a 1.3 lancer
now with the key
every time you incert the key into the ignition it reads the key as there is a chip in the orignal keys so thatway the immobiliser knows thatit is safe for the car to start
if the cra can not read the key it will not let the car start evan if it is twisting to start etc
you need to go to mitsubishi and have them copy some new keys and let them reset the codes on the immobiliser if you try to do so your self it may trigger a cold shut down
this is when the immobiliser its self needs to be replaces as well as the keys
hopes this helps
ricko
SOURCE: I have no heat in my 2003 Mitsubishi Lancer. When
The cable that pulls the cool/heat switch on the a/c gets weak and it doesnt allow the dial to switch over to heat. You can see that cable and the way its supposed to work on the right side of the gas pedal over it. I usually just use my foot to push that switch over to heat and reach with and pull on it with my right hand to cool.
192 views
Usually answered in minutes!
×