How do you remove and replace a headlight assembly on a 1995 Mercury Villager?
This is easy. Lift the lid open. Look at the back of the sealed beam and you will see a clip and an o ring. Pull the clip up and pull wires back toward the driver's seat. Unscrew the o ring and firmly pull the bulb out toward the driver again. Note the 3 tabs on the bulb seat and realign the new bulb with those tab ( 2 bottom, 1 top). Replace with #9007 bulbs..do them both.
You can not use 9007 bulbs on Mercury Villager 1995 it will not fit, you have to use 9004 bulbs.
I just had to replace a bulb on my '95 Villager and it required a #9004 bulb. The 9007 I tried to use first didn't fit. Not sure if it's a variation in different productions of the Villager or if the #9007 is actually an incorrect bulb for any Villager.
It is a bit of a time consuming job it would be best to get a diagram to see where everything goes as this will help you alot otherwise take to a mechanic.
cheers
any feedback left would be great
4,659 views
Usually answered in minutes!
how to replace speedometer cable for 1997 mercury villager
procedure for replacing 100 amp main fuse in 97 mercury villager under hood
replacement a knock sensor for a Mercury Villager 1998
×