Where is the blower motor resistor in a Ford Contour 2000?

Above the passenger's feet.

1. Disconnect the negative battery cable.
2. Remove the push pins and remove the upper footwell panel from under the passenger side of the instrument panel.
3. Unplug the connector from the blower motor resistor assembly.
4. Insert a screwdriver approximately 0.2 inch (5mm) under the edge of the resistor assembly to disengage it from the evaporator housing.
5. Remove the resistor assembly.
   

   
   

1. Position the resistor assembly into the housing and snap it into place.
2. Attach the resistor connector.
3. Install the upper footwell panel.
4. Connect the negative battery cable.