SOURCE: 2004 mazda mvp firing order
The firing order is 1-4-2-5-3-6. The cylinders are, front bank is from drivers side to passenger, 6-5-4 , and 3-2-1 at the firewall. This is for a 2004 Mazda MPV.
SOURCE: 1996 mazda mx6 ls cranks but won't start
you may need to run a wire from a keyed ignition source that has power while cranking and running to the fuel pump relay and bypass the pcm to test wether it will run, if it runs put a more permanent wire in place.Not too sure what tests youve done but it seems that fuel is what your focusing on so a quick test is too spray engine start up the intake tube to see if the engine trys to run if it does it eliminates a lot of other potential reasons for a no start condition.Also try squeezing the fuel return line to see if the added pressure will try to make engine run.Could be time to replace fuel pump etc anyway let me know how it goes good luck with it
SOURCE: how to replace ignition coil mazda mpv 2004
I show $47 for each coil at rockauto.com here is the part #
STANDARD MOTOR PRODUCTS Part # UF406
here is a picture, is this the coil?
SOURCE: how many catalytic converters on a Mazda Mpv 2003
I disagree. I believe there is 2 cats on the 03 MPV. If you look under the car. The 2 pipes from the headers meet right before the muffler. There is 1 cat under the vehicle and another right off the header (looks like an old glass pack muffler).
SOURCE: How do you change the alternator on a 2001 mazda
you must remove axle and plastic cover behind wheel exhaust section 4 bolt crossmember disconnect battery first 3 bolts on block for axle brace 2 bolts hold brace to axle tensioner pulley is reached from below support on jack stand far enough back so it doesnt get in the way good luck may the force be with you
275 views
Usually answered in minutes!
×