20 Most Recent 1992 Mazda 323 Questions & Answers

Ignotor

First I would check for fault codes, with a MEECs scan tool, next I would check the camshaft belt and the fuel pressure.

Have the brakes re-bled as it may be just air trapped on that side

This is normally under the dash on the drivers side. If you have the replacement part in hand it will help you identify it.

Sounds like the waste gate is having trouble. It could be what's called a "boost leak". the waste gate is most likely internal on a factory system. On the turbo, You'll see a small, vacuum pod looking thing with a linkage connected. Check to make sure the vacuum line/hose is properly connected and run that line to make sure it's not cracked some where. Otherwise, it could be any coupler, connection on the pipes that carry the air from the turbo to the throttle body. Even a "loose clamp" can cause boost leaks. With over boost, it's most likely the waste gate. Good luck. Hope ya find it.

take it to your mechanic if you have to ask you can't set it up

replace if faulty

its very tricky but you'll need repair kits and new gaskets

you probably have a hole or leak in your exhaust system

you can disable it by removing the fuse

check that the immobiliser is operating correctly. check the fuel manifold pressure for regulator operation

my check ligth on the dashbord is blinking

Have you adjusted your valve lash? This motor is an overhead cam motor and requires a rocker adjustment. Lots of info here:http://www.mazdabg.com/ftp-uploads/Mazda/323/AdjustmentData/Mazda32318i16VBP.pdf