At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
2009 Ford Fusion ... Front Proc 1 Note ... Front Proc 2 Note ... Do not attempt to tighten the nut with the vehicle on the ground or the wheel bearing will be ...
Dec. 2, 2019 - Im replacing the front wheel bearing assemble this weekend and cant find the torque spec for the ale nut. The older model Fusion (up to 2012) ...
If you have it apart, you should know already. If not, and you're doing this right, it should have four bolts, correct? I wouldn't worry about torquing them to anything specific, I'd tighten them snugly, then maybe 1/8 to 1/4 turn more in a criss-cross pattern. should be fine, they're not head bolts or lug nuts, so torque specs aren't necessary, but if you REALLY need the torque spec, I'd suggest going into an f-150 forum, sounds like a logical thing to do.
Main Bearing Cap Torque: Torque in 2 steps: Step 1: torque to 35 Ft/Lbs Step 2: torque to 70 Ft/Lbs The Rod Bearing Cap Torque:
45 Foot pounds (Final torque)
Was this what you needed...let me know by your rating of me...thanks!
torque specs dont really work with wheel bearings,its better to do it by feel,front wheel bearings with ratchet nuts,----usually tighten good and snug by hand and tap on the rotor a few times to seat the bearings,then good and snug again,not really hard,and back off 1/8 to a 1/16th of a turn,then tighten with your hand until it stops freely..you just dont want them too tight to wear out the new bearings
Wheel bearing don't have torque specs (to the best of my knowedge). They have a procedure - in this case it is....
1. With everything clean and packed with grease, snug the bearing lock nut until it stops.
2. Reverse it about 1/8th to 1/4 turn and insert the cotter pin.
Done
Differential bearing caps 70-85 ft lb
Ring gear bolts 70-85 ft lb
Pinion bearing preload if using original bearings 8-14 lb-in, if installing new bearings 16-28 lb-in
×