2007 Hyundai Santa Fe Limited Logo
Posted on Apr 11, 2010
Answered

How do I program the garage door openers located in the rear-view mirror?

Answer This Question

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.
New Friend:

An expert that has 1 follower.
Corporal:

An expert that has over 10 points.
Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 10 Answers
  • Posted on Apr 11, 2010
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.
New Friend:

An expert that has 1 follower.
Corporal:

An expert that has over 10 points.
Mayor:

An expert whose answer got voted for 2 times.

Joined: Apr 11, 2010
Answers
10
Questions
0
Helped
4472
Points
32

Try holding the button on the mirror down til you see a flashing light then push the button on your garage opener for the car to record the signal

4 Related Answers

swolfinor

STEVE WOLFINBARGER

  • 504 Answers
  • Posted on Jun 18, 2010

SOURCE: HOW DO I PROGRAM MY GARAGE DOOR OPENER IN THE REAR

GOTO HOMELINK.COM

THEY MAKE THE SYSTEM AND HAVE INSTRUCTIONS YOU CAN DOWNLOAD.

PLEASE NOTE: MOST BUT NOT ALL BRANDS/MODELS OF OPENER WILL WORK WITH THIS SYSTEM.

HOPE THIS HELPS

Ad
swolfinor

STEVE WOLFINBARGER

  • 504 Answers
  • Posted on Oct 21, 2010

SOURCE: How to reset rear view mirror garage door opener


GOTO HOMELINK.COM


THEY MAKE THE SYSTEM AND HAVE INSTRUCTIONS YOU CAN DOWNLOAD.


PLEASE NOTE: MOST BUT NOT ALL BRANDS/MODELS OF OPENER WILL WORK WITH THIS SYSTEM.


HOPE THIS HELPS

Anonymous

  • 869 Answers
  • Posted on Jan 04, 2011

SOURCE: PROGRAMMING THE GARAGE OPENER ON MY REAR VIEW

if u don't have the progamming code for ur mazda cx 7 then take it to a dealer or get codes from them by supplying VIN number.

Anonymous

  • 1 Answer
  • Posted on Oct 02, 2011

SOURCE: PROGRAM PRIUS GARAGE DOOR

There was a minor change for mine to work.. see below..

- you must park your Prius close to the gate opener, leaving it running (obviously not in the way of the gate closing)
- Hold the button the the mirror and then push your garage door remote button and hold until the light on the mirror starts to flasyh fast. THIS programs the button on the mirror, but not the garage opener - yet (this was key for me)
- locate the "learning button" on the opener itself
- press the "learning button" on your gate opener and then get back into the Prius within 30 seconds (more time than it sounds) and press the SAME Homelink button you just programmed above. I don't recall how long I held the pre-programmed button, but the light will flash as I recall.
- Then, when working the garage door, you may need to hold the mirror button for a good second for it to work - but I had tried for months to get mine to work, and finally after reading many posts, the above sequence worked on my 2008 Prius with my Lift Master, Security + rolling codes garage opener.

Just - program the button on the mirror with your remote FIRST.. the garage opener will not work.. then use the Learn button on the garage opener and the SAME BUTTON you just programmed.. and it worked great for me. Not programming the mirror button first will not work. Using only the Learn button will not work. You must program the mirror first with the remote, then use the learn button and the SAME button on the mirror. Hope this helps.

Scott 2008 Prius with Lift Master Security + opener.
-

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

Sinc garage door opener with a 2009 Hyundai Sonata
Take your remote and hold it up towards your rear view mirror or your visor whitchever is the one with 3 buttons of your homelink , also make shure that your opener has a program button which come in different colors depending on the year of the machine, if you have a program button on your powerhead of your garage door opener then you can mostlikely program your car to it! The button on garage door opener comes in different colors such as yellow,green ,orange, black, grey and black ! make shure your opener has one of these buttons! Now take your remote and point it within a few inches of your visor/rearview mirror and hold the button down that oppens that door....now press the first button on your car mirror/visor until the door opens up , it take sometimes a few trys but remember to leave your car running while doing this and have it outside the front of your garage door while doing this!
Read full answer
Dec 03, 2013 • 2009 Hyundai Sonata
0helpful
1answer

2012 hyundai tucson setting the garage door opener that is located in rear view mirror
Thanks filter4991;
1. Press and hold button on car's rearview mirror
2. Press and hold button on garage door opener's remote control.
3. Light on Rearview mirror will flash rapidly.
4. Release both buttons.
5. Locate learning button on garage door opener (generally this can be found by tracing the antennae to where it is attached to the unit.)
6. Press and release "Learning button"
7. Press and release rearview mirror button repeatedly until garage door opens/closes but it should work the first or second time.

Worked on Genie Intellicode and Hyundai Tuscon
Read full answer
Sep 20, 2012 • Hyundai Tucson Cars & Trucks
3helpful
1answer

Factory garage door opener
If this is the 3 button HomeLink Transmitter usually centered overhead above the rear-view mirror, this should work:

While the engine is turned off follow these steps to program up to three channels:
1. Decide which one of the 3 channels (one of the 3 HomeLink buttons) you want to program.
2. Press & hold the desired button through step 3.
3. When the HomeLink indicator light begins to blink slowly(this may take up to 30 seconds), hold your hand-held garage door remote about 1 to 3 inches away from the buttons & then press and hold the button on your garage door remote. Continue to hold both buttons until the indicator light on the HomeLink begins to flash rapidly(this may take up to 90 seconds).

If it still doesn't work, make sure the batteries in your garage remote are not weak, and try again moving the remote back & forth and left & right or turning it upside down while programming.

Also note HomeLink will not work with older garage door openers, especially not with ones manufactured before April 1st 1982.


Read full answer
Feb 18, 2010 • 2005 Buick Rendezvous
0helpful
1answer

HOW DO I PROGRAM MY GARAGE DOOR OPENER IN THE REAR VIEW MIRROR OF MY 2007 KIA SORRENTO
GOTO HOMELINK.COM

THEY MAKE THE SYSTEM AND HAVE INSTRUCTIONS YOU CAN DOWNLOAD.

PLEASE NOTE: MOST BUT NOT ALL BRANDS/MODELS OF OPENER WILL WORK WITH THIS SYSTEM.

HOPE THIS HELPS
Read full answer
Feb 08, 2010 • 2004 Kia Sorento
0helpful
1answer

Wife's 2004 MB E320 is having problem with the buttons on the rear view mirror that open the garage door. First button works, second button does not work all the time. Tried a total reset and...
Re-program
Read full answer
Feb 02, 2010 • Mercedes-Benz E320 Cars & Trucks
5helpful
3answers

PROGRAM PRIUS GARAGE DOOR HOW DO I PROGRAM THE BUTTONS ON THE PRIUS' REAR VIEW MIRROR TO OPEN THE GARAGE DOOR
There was a minor change for mine to work.. see below..

- you must park your Prius close to the gate opener, leaving it running (obviously not in the way of the gate closing)
- Hold the button the the mirror and then push your garage door remote button and hold until the light on the mirror starts to flasyh fast. THIS programs the button on the mirror, but not the garage opener - yet (this was key for me)
- locate the "learning button" on the opener itself
- press the "learning button" on your gate opener and then get back into the Prius within 30 seconds (more time than it sounds) and press the SAME Homelink button you just programmed above. I don't recall how long I held the pre-programmed button, but the light will flash as I recall.
- Then, when working the garage door, you may need to hold the mirror button for a good second for it to work - but I had tried for months to get mine to work, and finally after reading many posts, the above sequence worked on my 2008 Prius with my Lift Master, Security + rolling codes garage opener.

Just - program the button on the mirror with your remote FIRST.. the garage opener will not work.. then use the Learn button on the garage opener and the SAME BUTTON you just programmed.. and it worked great for me. Not programming the mirror button first will not work. Using only the Learn button will not work. You must program the mirror first with the remote, then use the learn button and the SAME button on the mirror. Hope this helps.

Scott 2008 Prius with Lift Master Security + opener.
-
Read full answer
Oct 30, 2009 • 2007 Toyota Prius
3helpful
2answers

How to program the suv morano garage opener
1. Press and hold the two outside garage opener buttons located on rear view mirror until the red LED light blinks (could be 20 sec.)
2. Press and hold the middle button on the rear view mirror while holding a garage door remote 1-3 inches away from the mirror and pressing the remote button. Do this until the blinking LED gets noticeably faster.
3. Once programmed - use the garage door opener on the mirror thru 3 cycles or more to verify.
Read full answer
Jun 26, 2009 • 2005 Nissan Murano
1helpful
2answers

Program garage door opener on 2005 nissan murano
All the info should be in the manual
Read full answer
Jun 11, 2009 • 2005 Nissan Murano
0helpful
1answer

Replace driver side mirror on 2001 Nissan Quest
SECTION 501-09: Rear View Mirrors 2001 Villager Workshop Manual REMOVAL AND INSTALLATION Mirror —Exterior Rear View Removal
  1. Remove the front door trim panel. For additional information, refer to Section 501-05 .
  1. Remove the upper speaker.
    1. Disconnect the electrical connector.
    1. Remove the bolts.
    1. Remove the speaker.
  1. Position the watershield aside.
  1. Remove the exterior rear view mirror access panel.
  1. Disconnect the exterior rear view mirror electrical connectors.
    • Release the wiring harness locator.
  1. Remove the exterior rear view mirror.
    • Remove the bolts.
    • Feed the wiring harness through the door opening.
Read full answer
Mar 31, 2009 • 2001 Nissan Quest
5helpful
2answers

Deactivating the garage door opener
If you hold the 1st and 3rd botton down in your honda built in remote for aprox. 60 seconds or until the light next to the bottons goes out, this will erase the program from the car. You shouldn't have to mess with you garage door opener at all.
Read full answer
Dec 23, 2008 • 2005 Honda Pilot
Not finding what you are looking for?

View Most Popular

2007 Santa Fe Limited

  • Cars & Trucks

Related Question

Sinc garage door opener with a 2009 Hyundai Sonata

  • 2009 Hyundai Sonata

Related Topics

793 views

Ask a Question

Usually answered in minutes!

Popular Questions

Car won't start after filling up the gas tank.

2004 Hyundai Santa Fe

Hyundai santa fe starter were

2004 Hyundai Santa Fe

Dome lights don't come on

Hyundai Santa Fe Cars & Trucks

My drivers side rear door will not open from the inside or outside

2007 Hyundai Santa Fe Limited

Check the accelerator position sensor on the pedal!

2004 Hyundai Santa Fe

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top Hyundai Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

PDF Manual
. 2007 Santa Fe Limited Manual

2007 Santa Fe...

Loading...