Need to know where location of IAT sensor is on 2004 jaguar x-type 2.5 not sure if it is integrated into maf sensor

DON'T USE WD40 on the air intake this will destroy the Lambda sensors,
for info on the location go here http://www.bluejag.co.uk/X-Type-MAF-Sensor.php

The Mass Air Flow (MAF) sensor/Intake Air Temperature (IAT) sensor is located in the air cleaner case.
// // 0) preLoad.src = ctl00_cphLeft_chRepairTreeNav_tvTOC_ImageArray[i]; } ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.lastIndex = 34; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.populateLog = theForm.elements['ctl00_cphLeft_chRepairTreeNav_tvTOC_PopulateLog']; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.treeViewID = 'ctl00$cphLeft$chRepairTreeNav$tvTOC'; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.name = 'ctl00_cphLeft_chRepairTreeNav_tvTOC_Data'; //]]>

The Intake Air Temperature (IAT) sensor is an integral part of the Mass Air Flow (MAF) sensor. Looks like this:

Hello mahnkes.

You did not mention what engine you have.
I have based this reply on a 6.0 liter gasoline engine.

The IAT (intake air temperature) is integral with the MAF that is mounted in the intake duct and if defective will need to be replaced as an assembly.
#2 in the diagram below.


I hope this helps you along.
Let me know if your engine isn't the 6.0

For Hyundai Car 1999-05 - Intake Air Temperature (IAT) Sensor Location (check several options):

1.- The IAT sensor is located against the firewall to the left side of the engine. It is combined with the Manifold Absolute Pressure (MAP) sensor.

2.- This sensor is located in the air intake plenum assembly. On some vehicles this sensor is combined with the MAP/MAF sensor.

3.- The IAT sensor is located in the air plenum assembly. On some vehicles it is combined with the MAF sensor.

4.- This sensor is located in the air intake plenum assembly. On some vehicles this sensor is combined with the MAP/MAF sensor.

5.- This sensor is located in the air intake plenum assembly. It is combined with the Manifold Absolute Pressure (AFS) sensor.

6.- This sensor is located in the air intake plenum assembly. It is combined with the Manifold Absolute Pressure (AFS) sensor.


In the next graphic, check the position 2...



FIG : Underhood sensor locations-Elantra 2004-2005 2.0L engine


Hope this help (remember comment and rated this) TY for using Fixya.

it's the sensor on the intake air duct come out of your air filter. the iat sensor is integrated with the maf sensor

The MAFS and IAT are in a single connector on the 04-08 MY F-150s.
This is for a new body style 2004, not the Heritage / Lightning models.

The IAT sensor is the Gray w/ Red stripe & Gray wire pairs in the connector. The connector is a 6 pin ( 1 row of 6 pins ) black connector.

The IAT is integrated with the MAF sensor on the 09 Fusion. The MAF is located near the air box on all three engines. on the driver's side, and will be held to some part of the intake tubing by 2 torx screws. http://media.photobucket.com/image/2009%20Fusion%20MAF/itsamecameron/fusion4cylengineMAF.jpg 2.3L shown, 3.0 and 3.5 should be similar.

it is the air Intake Temperature Sensor located at the air cleaner housing.

IAT is integral to the MAF sensor located on the air cleaner housing

most of times it is located on the big breather hose after the air filter