Where is the dodge 2002 intrepid knock sensor

2002 Dodge Intrepid Ignition Coil Circuit Codes: Electrical ...

www.2carpros.com/.../dodge-intrepid-2002-dodge-intrepid-ignition-coil...
Aug 13, 2008 - 2002 Dodge Intrepid 6 cyl Front Wheel Drive Automatic 130000 miles. Getting the following codes. P0353 P2302 P2305 P2308 P2311 P2314

What are 2002 Dodge Intrepid trouble codes PO442 and ...

www.answers.com > ... > American Cars > Dodge > Dodge Intrepid

What does the Error Code P0846 on 2002 Dodge Intrepid mean? .... Trouble code P2314 means: Ignition coil E, secondary circuit - malfunction Trouble code .

check and clean the cables in the sensor

yes. all a knock sensor does is slightly retard timing if the cylinders start detonating (pinging)

hayes has a great bible for your car i would sugest getting 1 and read a little

need more info

stop driving and check the oil if it looks like light coloured chocolate milkshake get it towed to a repair shop and have it redone.good luck

p0325 is the knock sensor
p0301 is misfire on the #1 cylinder
p0582 and p0340 i don't know

check to make sure the oil is full and in good shape ... if it is replace the knock sensor, drive it for 20-30 miles and recheck codes.

The knock sensor is threaded into the block of the engine, just below where the cylinder head sits. You will need to remove the intake plenum (upper and lower) to access this part.

Most dodge motors have adjusters on the rockers for taking up slack in the valve-train. when these get worn or plugged by dirt they turn the valves from soft hydraulic to hard ticking due to a space between the lifter and the valve. If this is an overhead cam with roller lifters then these have become worn or fouled.

The MAP sensor and Knock Sensor are both very easily replaced. A better scanner will tell you which sensor is going bad on your transmission. An Autozone code reader will not tell you which sensor on the trans. is acting up. Most sensors on your trans. are very easity replaced as well. They just screw in and plug it. It's worth paying to get a "real" scan done. The trans. sensors are inexpensive and you can replace any other your listed sensors yourself.