My brake, hazard and turn lights dont work, i

Buy a cheap multimeter and measure your voltage at the bulb when the brake lights are supposed to be on. You should have 12vdc. Is your 3rd brake light and brake lights on the same fuse? If not, measure to see if you have 12vdc at the fuse itself.

Sound like a bad turn signal switch. I would bet if you wiggled the switch in just the right position the brake lights would turn on.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

I have the same problem...it's in the hazard switch. It needs to be replaced. Try a salvage yard...the part is $122

Hi, you need to replace your signal switch. Please tell me your model and year if you need instructions.

you don`t say but do the lights work either on the front/back on both sides.if not then it may be a fuse that needs replacing or need a bulb replacement.if the lights work but don`t flash then it sounds like a signal flasher problem.the flasher is located in the fuse panel under the dash on the drivers side.if the hazard flashers work then turn them on to find the hazard flasher by the fuse panel then you will know what the signal flasher looks like and change the signal flasher.make sure you change the one for the signals and not the hazard one.if the hazards work then i would say the signal switch is good as the hazards work through the same switch.

Check the tail light fuse and check the bulbs. most likely have dual element bulbs so make sure both are good.

Check for power in and out of the switch with brake pedal depressed.If ok check to see if your hazard lights work you could have a faulty turn signal switch your brake lights feed through the T/S switch.Also make sure your bulbs are good.

TEST FRONT RIGHT BLINKER CIRCUIT AND REPLACE THE BULB,,WITH PROPER BULB...A DOUBLE CIRCUIT BULB IN A SINGLE SOCKET WILL DO THAT ALSO A SINGLE SOCKET BULB IN A DOUBLE SOCKET HOLDER....CHECK LEFT SIDE BULB FOR ACURANCY

Check the ground wire & leads, if not try the multi-function switch in the column

not sure if this helps but just had the same prob. my conction was rusted and was not making contact ? maybe unplug check for power with 12v test light