While resetting maintenance items I pushed the wrong buttons and car won't start now. Toyota flashes across the screen and cycles through again with the same screen reappearing.
Ex toyota tech here. That shouldnt have happened. I would just unhook the negative terminal of your battery give it a hard reset and see if that helps. You will need to reset all your settings after.
Odd? Call a Toyota dealership. Messing up resetting the screen after maintenance should not stop your car from starting. Something else might have coincidentally happened at the same time.
SOURCE: reset oil maintenance light in
Without multi-information display
With multi-information display
there you go jimmy mark as fixya
SOURCE: Reset the maintenance required light on my 2008 toyota corolla
OK ON YOUR SPEEDOMETER, THERES TRIP A, TRIP B, AND THE REGULAR ODMO... U NEED TO PUT IT ON TRIP A (WITH THE KEY OFF) ONCE U GET IN ON TRIP A, PUSH AND HOLD THE BUTTON DOWN,WHILE HOLDING BUTTON DOWN TURN KEY ON, YOU WILL SEE LINES POP UP ON THE ODOMETER, (WHERE THE MILES ARE DISPLAYED) THEY WILL GO OUT ONE BY ONE, ONCE IT STATES 0 YOU ARE GOOD TO GO.. GOOD LUCK AND THANK YOU FOR USE FIXYA.COM..KEITH..
SOURCE: Computer warning Oil maintenance 2008 Highlander Hybrid
Please email me on [email protected] and I will email you the procedure in printed matter.
Cheers
SOURCE: 2008 Toyota Highlander, low pressure light turned
Welcome to FixYa.
Note that the SPARE tire is also monitored. Reset the spare tire pressure, and then press the reset buttoen. You should be ok then.
SOURCE: 2003 Toyota Highlander clock resets when I turn off the ignition
Have you checked any fuses? Does the climate control light up? If not then in the under hood fuse box (left of drivers side) check the ECU-B fuse should be 7.5 amp. Check the heater fuse in the fuse box inside the car it should be 15 amp. If the fuses are OK and only the clock is bad check out my site www.autoclockrepair.com I offer a repair service.
43 views
Usually answered in minutes!
×