Aliement of the wheel
Read this forum that I am sending.
http://www.automotiveforums.com/t897353-discuss1999_windstar_camber_alignment.html
SOURCE: 2000 ford winstar with 198000 km
The codes are lean fuel condition for both banks. A very common problem with this engine that will set these codes are the upper & lower intake gaskets. You may experience a rough or rolling idle at cold start up and the condition will go away as the engine warms up. If you have checked all the basics such as vacuum leaks or air inlet leaks between the air filter box and the throttle body, then I would consider replacing these intake gaskets. Good Luck and please leave rating. Thanks
SOURCE: need to replace rear camber bolt on 2000 Hyundai Tiburon.
most front wheel drives do have a rear camber bolts on the inside of the lower control arm. you can change these yourself. just mark the rough position of the old ones knock them out and replace with the new bolts. probably 1/2 hour job. real easy but you will definitely need an alignment after.
SOURCE: will wheels from 1989 Ford F-250 4x4 bolt on to
Hello,
Sorry the 1989 F250 4wd wheels are not interchangeable with the 2000 F250 4WD.. The hubs where changed to a new design and (Bolt Pattern: 8 x 170MM) From 1999 to present...
Bill Andrade
SOURCE: i have a 2000 ford winstar with a code 1131 what
This has to do with your bank one O2 sensor. You may just need to clean it off, possible you may have to replace it.
30 views
Usually answered in minutes!
×