Go library to ck you engine specs but most cars are about 15 ft lbs if steel pump
1.8L motor; Water pump housing bolt 71 INCH pounds, no ft lbs
Water pump pulley bolt 15 Foot Pounds
1.4L motor; 71inch pounds and 16ft lbs
SOURCE: torque specs for 2000 chevy silverado truck 4.3 v-6 engine
Not sure what torque spec's your looking for.
Go to www.AutoZone.com, enter your vehicle information and check specifications. You should be able to look up the torque spec's your looking for.
Good luck.
Regards,
SOURCE: torque specs on Chevy Silverado 2500 rear diff yoke.
There isn't a torque spec since those bearing are pre-loaded. You place the unit on a good known vic and get a breaker bar and you might even have to put an extention on that and you begin to tighten unitil you fell the bearing start to load...a little extra short turn wouldn't hurt at that point.
SOURCE: torque specs for 1995 chevy 1500
Pinion seal nut. GMC Axle 270 Ft Lbs. Dana Axle 255 Ft Lbs.
SOURCE: torque specs for lifters 1997 2.2 chevy cavalier
You should buy a manual. If someone gave you an incorrect number you could have serious problems.
10,426 views
Usually answered in minutes!
×