SOURCE: Rear Windshield Wiper Problems
Check the wiper motor connection if its touching anything and loose it will automatically ground out and check at connection make sure you put some gel and then snap it in/ Please rate my response thank you very much
SOURCE: Wipers stop in the middle of windshield when turned off
check to make sure the wipers are at its right angle on the vehicle, loose the nuts and place both wipers close to the bottom of the wind screen
SOURCE: Rear windshield wiper broken 2007 Chevy Tahoe.
Once you get the nut off of the shaft use a pair of plyers or channel locks and wiggle the base back and forth it iwll come off and then you can replace the wiper assembly without taking anything else off.
SOURCE: windshield wipers only work on high on my 2002
you will need a new wiper switch. it is in the steering column. unhook the battery cables. you have to remove your covers on the coulmn. then remove and replace switch
SOURCE: 2003 Chevy SuBurban The windshield wipers will not
It is actually a wiper control module that controls this. I have replaced many of them. It is the cover that is screwed to the wiper gear box. Remove both wiper arms. Remove the plastic cowl cover below the windshield that covers from side to side. Once inside you will see the wiper motor/transmission assy. Disconnect the electrical connector, and remove screws from cover, and replace it.
724 views
Usually answered in minutes!
×