SOURCE: how to replace a coolant level sensor, 2000 buick century
The coolant level sensor is located on the radiator. If you are looking at the engine from the front of the car it will be on the left side. There will some kind of clip holding it in the radiator. Removed the clip and pull the sensor out. You will lose coolant so try to swap it out quick or drain some of the coolant out. Once new sensor is installed, install clip to keep the sensor in place and reconnect the wires to the sensor. Crank the engine and make sure the coolant level is full. This should correct your problem.
SOURCE: 2002 Buick Century anti-lock brake problems
i recently had this problem too, except i had all the lights on (ABS, service vehicle, trac-off, AND service engine) they are all easy to fix without spending more than 20-30$ for labour (depending how much your mechanic charges you) mine did it for free and he found out why the engine light is on afterwards too. so to fix all these lights (abs, trac-off, and service vehicle you MUST get another ABS cable (i went to a garage, they were towing a GM vehicle to the junk yard so i grabbed some scissors and cut BOTH abs cables on each side (good thing i did because one was bad) and braught them to my mechanic. the reason the lights come on is probably a defect or in my case my mechanic said it was salt buildup in the wires (on the drivers side) so he cut the wire off and rewired the new one and BOOM all the lights came off (service vehicle, abs, and trac-off) now for my service engine it says catalytic converter but im trying to put some fuel system cleaner to help it out i read somewhere that this is a defect of the car, so if you dont have that light yet, SELL your car ASAP for as much as you can get for it (after fixing the lights of course) and always google (car name+recalls) in the search bar to see what youre getting into, take care
SOURCE: Buick Century 2003 service engine soon light
My service engine light was caused by a cloged passage from my EGR valve. Mine is a 3.1 with fuel injection 2003. All I needed to do was pull the two bolts over the intake plenum and remove the vacuum connection to the PCV valve. Then clean out the EGR port just below the vacuum connection in the throttle port. I would remove the rubber intake to vacuum it out. The carbon was like rock in there. Service engine light cleared on its own.
Dave
SOURCE: hoe do i reset the service vehicle soon light on
u can do this by disconnectiong the battery negative cable for 5 minutes or use an electronic scanner to clear the light and the ciode for the light
SOURCE: Service Vehicle, Trac Off, & ABS lights 2001 Buick Century.
I just put in new fron pads in my 2000 buick century and the track off and the anti lock brake light and the service engine soon stays on
179 views
Usually answered in minutes!
×