2006 Buick Rendezvous Logo

Related Topics:

A
Allan rodrique Posted on Apr 11, 2018
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

2006 rendezvous 3.6 2 coolant pipes coming from intake to ?.need diagram of coolant system

1 Answer

jack layton

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Buick Master 5,569 Answers
  • Posted on Apr 11, 2018
jack layton
Buick Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Nov 12, 2014
Answers
5569
Questions
0
Helped
2398063
Points
20059

Can you follow the pipes to see where the go? Are they heater hoses/ pipes? They do carry coolant, correct?

5 Related Answers

Anonymous

  • 1605 Answers
  • Posted on Apr 13, 2009

SOURCE: coolant system problems

engine cooling should be a close circuit. there should have not over flow. however, the is a over flow container in the from of the car to catch any overflow.
the little tube may be the overflow tube that suppose to go to the overflow container.

Ad

Anonymous

  • 30 Answers
  • Posted on Aug 08, 2009

SOURCE: i need a copy (quick) for a 91 toyota 4 runner coolant system

http://www.ncttora.com/fsm/1990-1995_4Rnr/Toyota.4Runner.1990.1995/contents.htm

honeymokey

honeymokey

  • 3113 Answers
  • Posted on Dec 07, 2009

SOURCE: THE INTAKE MANIFOLD PIPE IS SMOKING AND MY CAR SENSOR SAYS MY COOLANT IS LOW. I HAVE CHECKED MY COOLANT LEVEL AND IT IS FINE. COULD THIS BE CAUSED BY A CLOGGED CATALYTIC CONVERTER? I WOULD APPRECIATE

The valve cover gaskets will leak and cause the exhaust manifolds to smoke. You will notice it when you park car or at a stop light.

Anonymous

  • 4044 Answers
  • Posted on Dec 12, 2009

SOURCE: I have a 99 chevy malibu I recently replace the

You replaced intake manifold gasket and now have this problem. Sounds like an overheating problem. It is possible you cracked the manifold when you tightend it down and that is letting pressure back down the water system but I don't believe that is likely. The only other time I had this problem when it wasn't the Thermostat sticking was when I had a head gasket leak to the coolant side. It let pressure into the coolant system and caused this but didn't exhibit leakage into the cylinders. Remove the thermosat and see if that relieves the problem. If so replace thermostat and enjoy. Hope this helps.

bigguy810

robert DIBBLE

  • 448 Answers
  • Posted on Apr 23, 2011

SOURCE: white smoke coming out of the tail pipe on my 2002

head gasket it sounds like you have a warped head antifreeze burns white remove and have it milled and magnafluxed to check for cracks that will core your problem

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2004 Buick Rendezvous CX. Where can I find the car radio wiring diagram for it please?

You buy a harness from the the aftermarket radio shop that supplies you with the new radio.

RADIO - Buick Rendezvous CXL 2004

Automotive Electricians Portal https://portal-diagnostov.com > 2020/04/04 > radio-bu...

Apr 4, 2020 - RADIO - Buick Rendezvous CXL 2004 - SYSTEM WIRING DIAGRAMS Base Radio Wiring Diagram, with Rear Controls. Get Access all wiring diagrams car.

2004 Buick Rendezvous Radio Wiring Guide

MODIFIEDLIFE https://www.modifiedlife.com > 2004-buick-rendezvo...
Our 2004 Buick Rendezvous radio wiring diagram shows you all the 2004 Buick Rendezvous radio wire colors and what they do. Use our 2004 Buick Rendezvous stereo ...

Buick (2004-2006) Century, Regal, Rendezvous Head Unit ...

PinoutGuide.com https://pinoutguide.com > ... > Buick pinouts
Jan 28, 2022 - OEM radio stereo harness pin assignment. Hardware connector pinouts and cables circuits ...

BUICK RENDEZVOUS 2002-2005 VEHICLE WIRING

JustAnswer https://f01.justanswer.com > BUICK+RENDEZ... PDF WIRING INFORMATION: 2002 Buick Rendezvous. WIRE. WIRE COLOR. WIRE LOCATION. 12V CONSTANT. ORANGE. Ignition Harness. STARTER. YELLOW. Ignition Harness.
5 pages
0helpful
1answer

2006 chyrsler sebring coolant reservoir empty everyday but o leaks

If nothing is leaking externally from engine area, then I'd have my exhaust analyzed for coolant coming out the exhaust. Bad intake gasket or head gasket usually indicated by coolant out the exhaust pipe.
0helpful
1answer

Where is the coolant temperature sensor?

should be on the intake near t stat
0helpful
2answers

2005 Buick rendezvous heater blowing cold and temperature gauge not working properly?

Faulty coolant temperature sensor and a faulty heater control valve.
1helpful
1answer

My husband and I are trying to get to our thermostat to change in my 2002 rendezvous, but there is a metal pipe in the way that we can't figure out how to remove. just behind the pipe, is a metal plate...

Hello vocalviixen,

The pipe that you referred to is the exhaust crossover pipe. Below I've included removal and installation instructions.

Also, the procedure for bleeding the coolant system is critical; if you need those instructions please post the question.

REMOVAL PROCEDURE
1. Disconnect the battery ground (negative) cable.
2. Remove the throttle body air inlet duct.
3. Drain the coolant from the cooling system.
4. Remove the inlet radiator hose from the engine.
5. Remove the thermostat bypass pipe.
6. Remove the exhaust crossover heat shield bolts.
7. Remove the exhaust crossover heat shield.
8. Remove the exhaust crossover pipe studs/nuts.
9. Remove the exhaust crossover pipe.
INSTALLATION PROCEDURE
1. Install the exhaust crossover pipe.
2. Install the exhaust crossover pipe studs/nuts.
3. Tighten the exhaust crossover pipe studs/nuts to 18 lb ft.
4. Install the exhaust crossover heat shield.
5. Install the exhaust crossover heat shield bolts.
6. Tighten the exhaust crossover heat shield bolts to 89 lb in.
7. Install the thermostat bypass pipe.
8. Install the inlet radiator hose to the engine.
9. Fill the cooling system with engine coolant.
10. Install the throttle body air inlet duct.
11. Connect the battery ground (negative) cable.


Regards,
netvan
4helpful
1answer

Thermostat replacement 2002 rendezvous

Thermostat Removal & Installation 3.4L & 3.5L Engine To Remove:
  1. Drain the coolant below the level of the thermostat.
  2. Remove the air cleaner and duct assembly.
  3. Remove the exhaust crossover pipe.
  4. Disconnect the radiator hose from the thermostat housing. gm_mv_ven_tstat.gif

  5. Remove the mounting bolts and remove the thermostat housing.
  6. Remove the housing gasket.
  7. Remove the thermostat.
  8. Clean the mating surfaces.
To Install:
  1. Install the thermostat on the engine. NOTE: Apply RTV sealer to the thermostat housing bolt threads.
  2. Install the thermostat housing and gasket with the mounting bolts. Tighten 18 ft-lb (25 Nm).
  3. Connect the radiator hose to the thermostat housing.
  4. Install the exhaust crossover pipe.
  5. Install the air cleaner and duct assembly.
  6. Fill the cooling system.
  7. Check the cooling system for leaks.
3.6L Engine To Remove:
  1. Remove the air cleaner.
  2. Remove the throttle body.
  3. Remove the heater pipes.
  4. Remove the coolant inlet pipe. Thermostat 3.6L gm-03-36-2447.gif

  5. Remove the thermostat mounting bolts and remove the thermostat.
  6. Clean the thermostat and heater pipe mating surfaces.
To Install:
  1. Place the thermostat in the housing with a new gasket.
  2. Install the thermostat and gasket on the engine with the mounting bolts. Tighten 89 in-lb (10 Nm).
  3. Install the coolant inlet pipe.
  4. Install the heater pipes.
  5. Install the throttle body.
  6. Install the air cleaner.
  7. Fill the cooling system and perform a leak test.
prev.gif next.gif
29helpful
3answers

I have a code P0128, what is my problem is this in the cooling system?

This code is for your Coolant Thermostat - It's detected that the Coolant Temperature is below the Thermostat Regulating Temperature

This code may mean one or more of the following has occurred:
  • Low engine coolant level
  • Leaking or stuck open thermostat
  • Cooling fan running too much
  • Faulty coolant temperature sensor (ECT)
  • Faulty intake air temperature sensor (IAT)
Check the following to see if it resolves your problem:
  • verify coolant strength and level
  • verify cooling fan operation and replace if necessary
  • verify ECT sensor operation and replace if necessary
  • verify IAT sensor operation and replace if necessary
  • if all above checks out, replace the thermostat
Not finding what you are looking for?

257 views

Ask a Question

Usually answered in minutes!

Top Buick Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...