2002 Hyundai Accent Logo

Related Topics:

R
Roy Seago Posted on Mar 31, 2018

How to remove internal plastic boot liners. Are there any screws 2002 Hyundai Accent. I have to fix a leak left rear corner,I think!

5 Related Answers

Anonymous

  • 566 Answers
  • Posted on Dec 19, 2008

SOURCE: 2002 hyundai accent needs brakes

hi from uk to renew front disc(rotors) and brake pads on the accent are not beyond the mech minded diy er and can easilly be done if you follow instructions on the haynes manual etc and would save$$$$s in dealer charges ? if you diy as for the rear brakes they are drum brakes with shoes that are auto adjust but again can be done by diy with help of manual ? as for cost of parts ? you can obtain/price of all parts from good auto shop/superstore also a manual ? then by all means obtain a quote ? for local garage to do the brakes with cost of labour and parts ? then consider option of diy? i am sure you will be tempted/inspired if you browse the work involved hope this helps? contact again if you feel lucky? will be glad to assist if you get stuck? or req info ? merry xmas from uk

Ad

Anonymous

  • 1509 Answers
  • Posted on Sep 15, 2009

SOURCE: how to remove door interior to replace the handle on 2008 impala

A trim tool used for all trim work that can be aquired at auto parts stores and tooldealers looks like a forked ended screwdriver with a 30 degree bend near the end inserted under the edges of the panel and pry out the pop connectors and the panel may need to be raised up just some to unhook the top edge but the bottom will need to swing out first. Power window switches should be unhooked first, the rear edge pried up first then the switch lifted and the wire connectors removed. there are light fixtures with either the blub to remove or the connector to unplug the inside door handle may have screws behind the trim that s removed with the trim tool also. It helps removing plastic parts when warm as the cold makes the pop connectors easy to break new connectors can be baught at auto body parts and auto paint stores and sometimes regulat auto parts stores. These stores also sell the trim tools

ghost45

PAUL MC G

  • 1280 Answers
  • Posted on Oct 04, 2009

SOURCE: 2002 Hyundai Accent 1.6 Check engine code

Take/Tow your vehicle to an authorized Hyundai dealership and pay the diagnostic fee... they will tell you exactly what the problem is and the cost of parts/labor to fix it... at least this way you'll know what the problem is and what's required to fix it.Go to www.hmaservice.com and register( Vehicle by VIN). Afterward, you have access to shop manuals, service bulletins, wiring diagrams, etc. about your vehicle.

Mustgo

Vincent G

  • 2363 Answers
  • Posted on Feb 02, 2010

SOURCE: I see some Oil leak near left side rear wheel when

If the source of the leak is betwen engine and trasmission housing then it will be rear main seal.

Most engine seals will leak if it is over 120,000 miles.

Anonymous

  • 6 Answers
  • Posted on Feb 20, 2010

SOURCE: Need to remove inside door skin on 2002 Hyundai

there is a plastic c-clip that holds the window handle on. you can use a screwdriver topry it off or a rag works well if you can get it stuck in the clip.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Hyundai 2002 accent removal of rear seat to replace fuel filter?

at the front edge of rear seat where it meets the floor will be two screws/bolts or sometimes pull out pins ,remove these and pull the seat towards the front and will release from the clips fitting is a reverse
0helpful
2answers

Rear wiper on 2002 Hyundai accent; hear motor, but rear blade will not move? Don't want to pay a fortune to have garage fix, is this an easy DIY fix? Any help is appreciated!

You will be needing to disassemble the whole rear door or lid. Inside you may find a plastic part broken. You should find a lot of plastic clips holding it all together, which clips will break when you start to take the door apart. Which clips may be very hard to find replacements, unless you go to Hyundai. Be blessed.
0helpful
1answer

How to fix the aerial on a 2002 Hyundai accent as the rubber has worn off around the aerial and just a hole now?

You'll have to purchase the part from the dealer and I believe it isn't that expensive. One word of warning though, make sure you paint the rubber with a good quality automotive touch-up paint or the sun will destroy the new part rather quickly, I learned the hard way! If I remember correctly, I believe I had to remove the trunk liner panel near the antenna and the boot comes off with 1 (?) screw. And while you are at the dealer, you might want to pick up the brake pedal stop switch urethane button, under $2, as these fail and when they do your brake lights will stay on causing a dead battery situation. The button is on the brake pedal arm just below it's pivot point and contacts the brake light switch. What usually happens is you find the urethane button laying on the drivers floor mat in pieces, then you discover the dead battery because the brake lights stay on several hours.
3helpful
1answer

Removing jaguar s type rear bumper..

disconnect the connector from the park aid module push the connector and grommet out of the back panel remove screws from lower rear of wheel arch liners remove boot floor trim remove plastic boot closing panel trim remove both boot side trims you wil find a number of 10mm headed bolts around the boot at the sides and back remove these and get someone to help you remove the bumper liner the 2 outer sensors can normally be changed without removing the bumper liner on some models
0helpful
1answer

My problem is changing the license plate bulb on a 2004 Hyundai Accent GT. They are seemingly impossible to get to. What engineering!

That's tough. You need to remove the plastic liner to get access to the connectors:
Remove all black screws off the plastic liner.
Remove small plastic cover at middle brake light using a small flat screw-driver.
Remove the yellow screw and the 3 black ones. This will relief the middle brake box.
You can unplug it (quarter-turn anti-clockwise) to ease further tasks.
Unclip the two narrow plastic covers on the side of the hatch back. Proceed bottom to top. There are 3 clipping slots. I broke the middle one on each...
Now you can unclip the big liner: there are 4 or 6 clipping slots at the bottom only. When you feel there is no more clip engaged, push the liner up. Unclipping is the toughest... Don't be affraid! There are screws if you brake one, anyway.
Enjoy the Korean engineering as I just did!
0helpful
1answer

How to remove the rear licnese plate screws stuck in the holes

drill the screw head off or grind it off, remove the plate, use a pair of pliers to hold the plastic base and a pair of vice grips to grip the shaft of the screw and turn it until it unwinds, remove the plastic base and replace with new ones
hope it works for you as it did for me
3helpful
1answer

Need to remove inside door skin on 2002 Hyundai accent. Something let go and outside handle no longer working. Inside still works. How do I remove the window winder before I begin with screws? Sandra

there is a plastic c-clip that holds the window handle on. you can use a screwdriver topry it off or a rag works well if you can get it stuck in the clip.
0helpful
1answer

I see some Oil leak near left side rear wheel when the vehicle(Hyundai Accent ) is PArked What could be the Issue?

If the source of the leak is betwen engine and trasmission housing then it will be rear main seal.

Most engine seals will leak if it is over 120,000 miles.
4helpful
3answers

Replacing exterior door handle 2003 hyundai accent?

remove door panel which is attached by screws,peel away plastic liner and look inside door at back of door handle..using needle nose pliers pop off the small steel rods that are for inside door mechanism,then remove the one bolt that attaches the handle to the inside of door and from outside of door remove handle.Replace in reverse order!
0helpful
1answer

Left side only speakers stopped working for a 2002 Hyundai Accent

you probably pulled the left speaker wires apart when trying to get it out. there should be enough slack in the wires to pull out or they wouldn't have been able to hook them up. the only way to fix it is to take the player out. if you don't think you can do it have someone who can do it. ( the wires might just be caught up on something, try wiggling a little to free them)
Not finding what you are looking for?

382 views

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...