SOURCE: input/turbine speed sensor circuit
Your speed sensor, is located on top of the transaxle, near the starter. To access it, remove the battery, then remove the battery tray (4 10mm bolts). You will see wires coming from the lower oxygen sensor, and they snap into the bracket that holds the speed sensor in place. The actual speed sensor has a 2 wire clip on it, and is held in place by the bracket and a 10mm bolt.
SOURCE: 2006 Ford Fusion SEL - TPS
The TPS is an easy part to replace. It has 2 screws and 1 electric connector. It is about the size of a butane lighter and attaches to the metal airhorn.
There is only a slight adjustment possible for this part. One end has an elongnated slot for the screw. Just look at where the old part was adjusted and replace it that way. The only thing you need to watch is aligning the slot on the throttle shaft with the indentation on the TPS.
While you are replacing the part, disconnect the battery on the POS cable and this will reset the "check engine" light on the dash. Then reconnect and drive your car.
SOURCE: 2006 Ford Fusion. Left front door inside handle
This link is from the handle to the latch. The door panel has to be removed in order for this problem to be fixed. The linkage is inside the door panel, it is a small diamater metal rod called a link. If you do the job yourself be careful not to break the door panel. In a shop, the labor is 1 hour for the job & if any, parts will be a seperate charge.
SOURCE: 2006 Repair Manual Ford Fusion 1.4
autozone.com sign up its free then click on repair manuals you will find all of your info there....good luck
SOURCE: my 2006 ford fusion check engine light is on and
P0882 - TCM Power Input Signal Low, this is a transmission code, I recommend that you take it to a dealer or qualified transmission shop. Hope this helps.
376 views
Usually answered in minutes!
×