Whats the torque valueson the brake caliper 2008 chevy silverado 1500 4x4 crew cab

SOURCE: bad sensor on chevy truck

There are 2 both located in the block..

SOURCE: Front Hub Bearing Torque specs to complete replacement

THE LUG NUT TORQUE SPEC - 140FT/LBS\
CALIPER MOUNT - 80FT/LBS
CALIPER BRACKET 129FT/LBS
AXLE NUT 177FT/LBS

SOURCE: how do i change my upper and lower ball joints

Jack up the car remove wheel remove brake caliper and remove rotor rent a ball joint press remover and installer tool (at schucks you get money back when you bring it back) if it's 4 wheel drive you will have to remove the axle shaft next pull the snap ring off on the top side and put tool on the lower tie rod end and press out, next do the top press out top joint next sand ball joint sockets so it is clean lube with WD-40 next press in top ball joint and then lower ball joint. In this order otherwise you will have to un install the top ball joint by removing the pin then nut.

SOURCE: 2008 Chevy Silverado power lock problem

we have a 08 1500 crewcab chevy that all the power door locks worked excepted the drivers door. We started to look at that door power lock actuater and now the passenger power door lock does not work. Could the trouble be something other than actuaters?

SOURCE: i have a 2008 chevy

This is a very common problem on all chevy trucks for this year. The door lock solenoids are integrated into the door latch assembly, and are notoriously weak. They will work fine sometimes, others they just seem to barely move or not at all. You will need to replaced the door lock / latch assembly for the affected door.