How to replace the headlight assembly on a 2007 Sebring

SOURCE: Replacing headlight in 1996 Chrysler Sebring JXI

piece of cake....
take off the two "star" bolts, one toward the center of the engine above the light assembly and the other toward the fender (it is very long). when you remove them both the entier assembly falls off into your hands and makes changing the bulbs much easier.

SOURCE: headlight assembly

Hello streets54, my name is JShreader. Thank you for choosing fixya.com.

First, you have to remove the Upper Radiator Grille. Behind the Headlamp at the top of the Front Bumper, access the lower inside hidden Headlamp Bolt. Only loosen the Bolt. DO NOT REMOVE. Now remove the 2 Headlamp Screws, then the Hidden Screw...now the Headlamp Housing should come out. I uploaded the procedure in .pdf format. You can download it by clicking HERE. I hope this helps you. If you have any more questions or need any more diagrams, please don't hesisitate to ask...Thanks again, JShreader!

SOURCE: how do I replace the headlight assembly on a 2006

1. Remove the front bumper cover
2. Remove the upper headlight housing mounting bolt and pushpin
3. Remove the lower headlight housing mounting bolts
4. Pull out the headlight housing assembly and disconnect the electrical connector.

Its pretty easy. Just raise the hood, see the two silver 8mm cap screws on top of the cross member that supports the radiator and fan assembly. Two screws on each side above the headlight housings. The outer screw is right next to the corner of the fender when the hood is raised. Remove the two screws, then the headlight assembly is loose. Just gently pull the headlight assembly forward enought to see the three lamp socket holders on the back side of the headlight assembly. From the outside corner to the inside are first, the parking turn signal, then the low beam lamp and finally the last, the high beam lamp. To remove the lamp socket, push the small plastic locking tab and turn the socket assemby counter clockwise about a half turn and remove the lamp. Now you can replace the lamp and install it back the same way you took it out. Don't touch the new lamp glass with your bare fingers. Oil from you skin will absorb into the glass causing the glass to turn dark and shorten the lamp life. 

SOURCE: How do I replace a headlight assembly on a 2007 Buick Lucerne?

i remove all four bolts that I could see from the top side