Maybe related: Odometer digits slowly disappearing and never returning. Begining with the leftmost digit). Windshield wiper malfunctioning. works then stalls switching on/off several times it revives. Is a common electrical malfunction causing these issues?
If the battery is removed you have to re-align the windows to the fully up position. So, get the window to the top and keep your finger on the button for about 3 seconds you will hear a click. the next time you operate it will go all the way up in one go.
If this does not cure it the battery connection may the problem.
SOURCE: 1998 Mercedes Electrical / Electronic Issues
Hi,
From all indications, most of your devices are controlled by a common module. This would be similar to the engine management computer but has the responsibility for all those mentioned and then some. if you would notice, most if not all are non essential to the engine's performance. Initial suspect would be such a module and/or the sensors, connectors to it. Being such as multi input and multi output, it is perhaps to your advantage to seek the services of a qualified professional. If you are considering a DIY (do-it-yourself), then access to a full service manual would make things doable if not easier.
Often this control module would be under the dash or on any of the kick panels.
Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.
Good luck and kind regards. Thank you for using FixYa.
SOURCE: how do you time a 1995 Mercedes C280 inline 6 cyl?
hi,pls. remove the cylinder head cover,try to rotate the crankshaft on ot position,then look the hole 5mm in intake and exhaust sprocket,install 2 pcs. of 5mm pin with align on surface of cylinder head,ot on crankshaft pulley and two sprocket lock in the surface of head ,you have a104.941 engine,ty
SOURCE: I have a 1995 Mercedes C280 and the windshield
You need to remove the cover at the base of the blade and oil or grease the mecanism that makes the wiper move up and down and it moves across the windshield. It is dried out and sticking.
SOURCE: my window wiper works fine but always stops half
Pop the base off the wipe where is attached to wiper motor. Loosen the nut on wiper and move to the bottom and tighten. Should work properly now. Likely loose now which is why it got this way.
SOURCE: I have a 1996 Mercedes-Benz C280. My turn signals
hello,good day,hoping your fuse is in order,may check your fuse in engine room,if ok,better to send your car to your dealer,because signal light and wiper system is connected to a control module,to avoid parts replacement not deffective,ty
59 views
Usually answered in minutes!
×