1998 Plymouth Voyager Logo

Related Topics:

Erin Eckenrode Posted on Oct 09, 2016

1998 Plymouth Voyager replacedbattery hazards flash and security alarm going off. s

5 Related Answers

motor1258

Mike Butler

  • 6674 Answers
  • Posted on Apr 11, 2009

SOURCE: 1998 plymouth grand voyager cruise control relay/fuse location?

Check under hood in box marked fuses & relay, on drivers side and look under cover of it for I.D.

Ad

Robert Debison

  • 412 Answers
  • Posted on May 10, 2009

SOURCE: have a 1998 plymouth voyager and the insturment panel and gauany suggestions to fix the problems?and headlights went out are there ges

try a battery disconnect..have seen a body control module lock up on these vehicles

Anonymous

  • 161 Answers
  • Posted on May 25, 2009

SOURCE: i have a 1998 plymouth voyager and the insturment panel and gauges and wipers and locks stopped working how could this be fixed

you have to replace the " body control module " located under dash drivers side. and most of time they have to be reprogrammend unless you buy it new from dealer and they do it before you get it. the body control mod controls all those items and go bad alot.

Anonymous

  • 1985 Answers
  • Posted on Dec 06, 2009

SOURCE: replace blower motor 1998 plymouth voyager

it is located behind and below the glove box,you might want to remove the glove box assembly to see it easier,
there are four screws holding a blower motor cover you to take off first,now remove the screws holding the blower motor up,disconnect the motor wires.
if your changing this because you think its bad,you should test the blower motor wires with a test light with the key on and blower switch turned on.if you have power in the wires,then it is bad.
but if you have no power in wires it could be blower motor resister,or switch.

Anonymous

  • 1206 Answers
  • Posted on Jan 06, 2010

SOURCE: Where is hatch sensor for 1998 Plymouth grand voyager (3.3 FLEX)?

its built into the lock mechanism lock might have to be replaced try adjusting it first. should be able to move the latch.

Testimonial: "A true expert. Makes sense to me."

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
2answers

Kill switch on 1998 plymouth grand voyager

Just because the lights go on does not always mean that the battery has enough power to engage the starter. The clicking noise could be the voltage regulator clicking. And since you disconnected the battery maybe there is not a great connection at the terminals. Were the terminals cleaned before the battery was reconnected?
Curious ... what was the cause of the check engine light going on?
0helpful
1answer
0helpful
1answer

Lights on a/c flash on and off this started when i couldnt get it to start got a jump then the security was acting goofy had to put security key in to start it and now a/c dash lights flash

1998 Plymouth Grand Voyager-similar happen to me when my battery was very low. I replaced the battery, then rear wiper control lights flashed, a/c control lights flashed.
HVAC controls need to be recalibrated, this is a factory test that involves pressing these control buttons in a certain sequence, which may take a couple minutes to complete. I'm sorry I don't have the written steps to share, but I hope this leads you to a solution.
0helpful
1answer

Alarm is going off and the Plymouth Grand Voyager won't start.

Try using your key (after reconnecting battery) on the drivers door, to lock, and unlock it. There are so many different vehicles with different methods, you may have to call dealer service dept, with your VIN # and name, and they should be able to give correct procedure to disarm security system. Check owners manual as well.
0helpful
1answer
0helpful
1answer

The locks jump up and down when i drive,sometimes wont start

the security system problems are common on this - do the lights flash and horn cycles when it locks up - the security system is wired into car main computer - can't be bypassed as far as i know - i read that to get around this lock doors manually - no key or remote - also hood switch could be problem
0helpful
1answer
0helpful
1answer

Manual windows to power windows

Yes you can do, The best place to this job, can be a alarm instalation place., or electricist man.
Not finding what you are looking for?

41 views

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...