E-brake won't release 1998 Sierra 1500

Hydraulic system, suspect bad master cylinder and/or booster. Check brake fluid level. Have brake system pressure bled and complete system checked.

Sounds like the master cylinder is not releasing. Replace it

sounds like your switch on the brake pedal is bad or the wire between the pedal and the lights

THAT PART ABOUT BARELY GETTING HOME BOTHERS ME LOW VOLTAGE TO COMPUTER CAN BURN IT OUT HAVE IT TESTED GOOD LUCK CHECK RED FUSES

you should be able to find it somewhere around the area of brake pedal under the dashcheers

Push it ALL the way down then release your foot, should come back up.

Hello my name is Israel and I will be glad to help you. Above the brake pedal there will be a small white in color switch with two wires coming out of it. This is the brake switch. You will need to pull the pigtail from the brake switch and then "unscrew" the switch and replace with new one. Connect the pigtail. Adjust the switch so that the brake lights activate with a touch of the brake pedal. Good Luck.

check for front brake calipers dragging, if the are replace calipers and front brake hoses, if calipers ok replace master cylinder, This is how to check calipers, jack up front of truck have some one apply brakes and release as soon as they release the brake peddle the wheels should spin freely if not brake the brake line lose at master cylinder if wheels spin free with line loose replace master cylinder, if not replace calipers and hoses.....HOPE THIS HELPS

No, there is no adjustment aside from being certain calipers are not binding. Be sure the M/C is fully releasing.

Can you get to any part of the cable? If so, use a pair of pliers to release it until you can replace the cable.