Hi there my name is Brandon Im a electronic n mechanical engineering technician Im not a regular mechanic I fix what regular mechanic cant or don't know what is wrong but I will be more than happy to help you out!!! OK I have to get little more information to be 100 percent what I would start with is grounds for the cluster panel n body also take a computer safe test light to the fuses n don't for get you have to test Evey thing electronic with a loaded circuit or the test WILL NOT be RIGHT check the cable for your speed..... thats is a few things maybe not it but its a start but please feel free to write back n ask questions bout testing or how it don't matter n pretty pretty please give me more information like make model years more etc!!!! Not trying to be rude bout it sorry if it sounds like it but I will give you my personal email address and email me the information n if you can take pics of it with it off n with It on
P.S I am working in the shop so if I don't get back to you right off I will I promise you I will A.S.A.P today
God bless you,
thank you
Your engineering technician
Brandon
([email protected] )
SOURCE: 1998 plymouth voyager gauges on dashboard not
well start by checking all fuses but it sounds like a bad ground wire somewhere on the car
SOURCE: the odometer speedometer gas gauge and heat gauge do not work
There has been issues with the solder joints on the PIN connection to the gauge cluster. The issue being that over time thru vibration and such one of these solder joints will fail (happened on or 1999) you can repair this though. You will have to remove all of the trim from around the driver's side dash board, this will include the trim towards the center of the dash. Once these pieces are remove you'll need to remove the gauge panel (I believe (4) allen head screws) carefully bring the panel and release the wire clip from it. Looking at the back of the panel, where the plug was, carefully with plenty of light look for one of the pins to have a failed solder joint. It will be very faint however the failed joint will be a fine dark line around the pin. To correct use a small soldering iron and reheat this solder until it wants to flow, let it cool and reassemble.
I hope this may have helped,
Tom
PS: I have helped several persons with this issue, please review my profile; good luck with it (also often times with this issue the ABS light stays on)
Testimonial: "thank you you are the only person who had an answer I will try and let you know"
SOURCE: on my 1999 chevy silverado the only gauges that
The stepping motors in the gauges go bad. Do a search on ebay for CHEVY SILVERADO INSTRUMENT CLUSTER for cheaper repair options, dealer costs $300.00
SOURCE: speed dometer,fuel gauge does not work on 1993
sounds like the ballast resistor on the back of the dash unit
49 views
Usually answered in minutes!
×