Ford crown victoria 99 won't go forward goes in reverse

Need tranny pro for your dilemma.

Trans is shot

Sounds like it could be the the transmission or the gear box. Also what's going on with the axel rod?

I would but imagine that since it goes into reverse, the shift lever is connected to the transmission. Makes sense. But won't go into forward gears with the selector/shift lever. Your either very low on trans fluid or you've burned the clutch packs out from being low on trans fluid. Only makes sense.

Replace the transmission.

well let me explain if? the pulley was spiining on thr shaft to begin with on the pump..putting a new pulley on a worn shaft won;t work!! there is 2 ways to fix this!! one is if this is the case then you can use JB weld around the shaft and i mean use it and even put some inside the pulley then put the pulley back on the shaft let set for 4-6 hours before running the engine also you can go to a manchine shop or a parts store and ask for a roll of brass shim stock about .03-.05 thousand's and rapped a few times around the shaft to create a tight fit when you press the pulley back on making sure you leave about a 1/4 inch extended past the end of the shaft so it will go in the pulley on install

Most likely the forward gear has broken that means you need a rebuild or a new transmission ......But thats my opinion I had the same thing happen to me and most of the time it works only in reverse that means the forward gear has broken....Hope this helps and sorry for the bad news....

sounds like the tranny is low on fluid or the tranny is going out try manuly puting the tranny in 2nd gear and see if it will move

Look like internal transdmission problem - reverse gear is broken. Common for 2005-2006 CVPI

forward clutch set in trans... aamco is very good and reasonable.