I am needing a radiator, mass air flow sensor and the turn signal switch. Will be needing body parts later.
Ford explorer
If you need further help, I’m available over the phone at https://www.6ya.com/expert/mike_9693b5ad75773352
SOURCE: Replace thermostat in 2000 ford ranger
the open pipe that you took the hose off of is the thermostat housing, you will need to remove this to reveal the thermostat, make sure you use a new gasket with sealant when reinstalling thermostat housing to prevent leaks and dont over tighten the bolts,run both bolts down as far as you can before final tightning
SOURCE: need location of the erg sensor 2000 ford ranger
The egr valve has two sensors. One is an EGR position sensor which is physically attached to the EGR valve. The other sensor is the DPFE (Delta Pressure Feedback EGR) sensor, commonly called the EGR pressure sensor. It's location varies depending on the engine you have. You can fine this sensor by following the vacuum hose on the EGR valve. It will be with in inches of the EGR valve. The sensor will be black (plastic) or silver (metal), have two or three vacuum ports and an electrical connection on it.
The vacuum pressure sensor is a high failure item on fords. Any Ford parts department will have one in stock, as well as some aftermarket parts stores.
The new sensor may not look exactly the same as the old part, but will have all the hook ups as the old one. You may also need to replace the vacuum hose to the sensor as well
SOURCE: 1990 Ford Ranger Stalling
if it were me I would start with the idle air controll sensor, this is a real humdinger on fords. also clean out your throtle body really good.
let me know
tepfy
SOURCE: location of mass air flow sensor
The sensor is mounted on the throttle body between the air cleaner assembly and the air cleaner outlet tube.
Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.
332 views
Usually answered in minutes!
×