Cars & Trucks Logo

Related Topics:

s
shelton fehr Posted on Dec 09, 2014

My gauges dont work on my 85 fiero, how do I fix that?

  • shelton fehr
    shelton fehr Dec 11, 2014

    thank you ill keep that in m ind

×

1 Answer

Gregorio M

Level 1:

An expert who has achieved level 1.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 48 Answers
  • Posted on Dec 09, 2014
Gregorio M
Contributor
Level 1:

An expert who has achieved level 1.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Jan 26, 2008
Answers
48
Questions
0
Helped
14608
Points
53

Sadly your car is very old. But the good news is scap yards keep so man parts off any type of old cars .. Check with a mechanic first for the problem first make sure what it is !! and then if it needs changing call around. Could be a wire problem to the fuse could be anything check it out first.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

The battery and oil pressure gauge pegs - 1987 Fiero GT

check for a pinched wire that goes to the gauges.. its grounding out.
1helpful
1answer

I replaced the timing gears and chain in my 85 fiero gt and it wont fire up ive checked the compression and tried 123456 and that dont work

Thats the correct firing order 123456,You know on those engine the push rod tends to fly out and the rocker arm nuts tend to loosen out.
0helpful
1answer
0helpful
3answers

No power to horn on 85 fiero, good fuse ,good ground, new relay and tested horns thier ok any ideas?

Go to Pennock's Fiero Forum and ask this question there. They will help you. Ask under Tech.
0helpful
1answer

Need to fix emergency brake in my '85 fiero. How does one go about doing such things.

I'm assuming the issue is that it will not pull tight enough to hold the car.

If my assumption is correct, you will find a steel cable at the rear of the car running left to right to the back of the brakes, there is an adjustment nut that you can tighten to take up the slack. Be sure to not over tighten so that the rear brakes are rubbing even when the ebrake is not pulled.

Hope this helps.
0helpful
1answer

1984 FIERO 4 CYL STICK. had a aftermarket elec temp gauge mounted on console, replaced with a mech temp gauge. after replacing temp gauge is when the fuel gauge messed up. now when you turn on the key or...

I assume you replaced the temperature sending unit when you installed the aftermarket gauge? You need to put the proper sending unit back in for the OEM gauge to work.

You can find a sending unit here (and a gauge if needed):

http://www.fierostore.com/

Hope this helps
2helpful
1answer

My 85 fiero gt smokes after reving the engine. What is it?

It is either oil,or rich fuel burn,and if it is white smoke,it could be coolant.
0helpful
1answer

85 Pontiac Fiero - passing a smog testing

Could be vacuum or O2 sensor maybe using cheap fuel.
0helpful
2answers

1985 fiero been having problems getting in gear. Now wont turn over starter. New starter didnt fix problem. Dont know if 2 problems are related. Can push start.

Have same car, same problems, easy solutions.

Getting into gear has been improved by putting in neutral with engine running to warm up fluid. The Fiero has very little room in the pedal area. I'm shifting a lot better with smaller shoes.

The problem with starting may well be related to the same issue. There is a neutral safety starting switch. If you're not pressing hard enough on the clutch - starter won't run. According to the Fierostore.com stock clutch pedals tend to bend. They sell a stronger replacement.

My Fiero has been starting just fine the last few days. The last time it didn't I was wearing boots.

I've almost always been able to get it to start using a booster battery, but Walmart's tester indicates that the battery and charging system are fine. It recommends tightening connections. I did this, but still had problems for a while.
Not finding what you are looking for?

160 views

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...