I have a Jeep Grand Cherokee Laredo that did not come with fog lights. I plugged the fog lights I bought into the existing fog light harness but they will not come on. Am I missing something or doing something wrong?
If it didn't come with fog lights, it may also have not included a fog light relay and/or fuse. Check the owner's manual for fuse and relay locations, and then check if the necessary parts are there.
You probably need the other end of the harness that connects to a switch in the dash as they have to be independent of the head lights by law. Check for a fuse that is missing in the fuse box.
SOURCE: 2002 jeep cherokee laredo
the only problem that vehicle has is with cooling fans is relay/module or electrical harness to module that burns up located behind and under right front headlamp assy must remove headlamp to access relay/module that is what powers up fan motor module assy.
SOURCE: Airbag light indicator: Jeep Grand Cherokee 1997
there are many sensors and and each airbag have sensors so you will have to get it scanned to know where to start. just a note air bag parts can be very expensive so check out your local salvage yard. they can save you hundreds. good luck
paul
SOURCE: change a serpentine belt on 04 jeep grand cherokee laredo
Check this link & scroll down to your engine. Click on picture to expand.
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528004328a
SOURCE: The interior lights for my 1996 jeep grand Cherokee Laredo
Hello and welcome to FixYa
The interior lights wont turn off cant because it can't get a conncetion definitely a headlight switch issue common problem for that make
Part # 05137535AA Headlight Switch Probably a dealer item very simple to change this yourself. Hope this gets you going.Please Rate Me. And you can always Ask Me.
SOURCE: 1998 Jeep Grand Cherokee Laredo 4.oL I got a code po113
Trouble Code: P0113 (4.0L L6 VIN S Auto)
IAT Sensor Circuit High Input
Print this code data
Number of Trips to Set Code: 1
OBD II Monitor Type: CCM Details
Indicators: MIL Details
Trouble Code Conditions:
Check with ignition on or engine running; battery voltage more than 10v; The PCM detected the IAT Sensor input was over 4.90v (exc. Dakota, Durango, Ram) or 4.98v (Dakota, Durango, Ram) for 3 seconds.
Possible Causes:
483 views
Usually answered in minutes!
×