2002 Grand Caravan. Overhead console lighted switches are not lighting. The Map lights that shine straight down works but none of the others back lights. Side door switch,rear gate switch, garage door switch,etc are all dark. Is this a fuse problem or are several lamps out?

I would test your fuses but if that is not your problem your dash light dimmer switch may have gone bad. or is turned down all the way if this was helpful please leave good feed back

Make sure the air pressure wheel OK first , let me know .

If the lights in the overhead console work then it is not a fuse, it is a bad console. These units are poorly designed and fail frequently. We offer a repair service with a lifetime guarantee. Check out www.autoclockrepair.com. Drop us a note if you have any questions, thanks!

The bulbs is replaced from the back of the overhead console with 1/4 turn bulb holders.

the overhead console ( non rail version ) is held up with spring clips.

Open the rear compartment, and grab the rear corners and pull down 1 at a time. They are very hard to pull the 1st few times. Once you have the read released, there is another set of spring clips in the front, so be careful how far down you pull the rear, until the front is released.

Once you can see the back of the overhead console, you will see the 1/4 turn bulb holders for the map and interior lights.

If you're talking about the map lights (2 lights in between driver and passenger)

If you have just the map lights, just pull the whole assembly out. Don't worry about anything breaking, just pull it down, just not at an angle or anything. It easily snaps back into place after. Bulbs can be removed once you have it out.

If you have an overhead console, you remove a screw towards the front of the overhead console Then just pull. If you're talking about other interior lights, let me know I'll let you know how to remove it.

lamps out

Make sure that when you check the fuses you use a test light applied to both sides of the fuse you are testing.It can be very difficult to see a fuse that is blown when the fuse is blown near the edges. PS the dash fuse is by itself and needs to be checked when the light switch is on.

same problem. I finally solved it by buying a new circuit board with display from a junk yard for $35.00 and replaced it. they let me try it out there before i had to buy it. Works fine now.

the visor clip is made in 2 parts. the outer cover needs to slide straight down which releases tension of the inner clip which is wedged in by the outer cover.

Have you tried a junk yard? I found a match to my console, just different color.